【精品】基于nRF2401模块的无线温度监测系统设计 毕业论文.doc

基于nRF24L01模块的无线通信系统设计 摘要 温度是一个非常重要的参数。在工业、医疗、军事和生活等许多地方，都需要用到测温装置来检测温度。传统直接布线测量不满足要求，特别是在某些环境恶劣的工业环境不现实因此采用温度检测尤为必要。目前有些设计能够实现无线温度采集，但过高是其最大的缺点。在实际温度控制过程中既要求系统具有稳定性、实时性又需要因此设计一种低功耗的无线温度检测系统很有意义。本文提出一种采用单片机实现的无线温度测量系统。该系统能实现对温度的检测，能够同时进行温度检测，是可以实现远程控制的无线温度检测系统。低功耗、实时性的无线温度检测是该设计的最大特点。DS18B20 Abstract Temperature is a very important parameters. In the industrial, medical and military and life and many other place, it needs to use the temperature measurement device to detect temperature. The traditional direct measurement wiring does not meet the requirements, especially in some environmental bad industrial environment and outdoor environment, through the direct wiring measurement is not practical. So using wireless transmission temperature testing is necessary. At present some design can realize the wireless temperature gathering, but the price is too high, its biggest weakness. In the actual temperature control process requires both system has stability, real-time and the need to reduce power consumption. So the design of a kind of low power consumption wireless temperature detection system is very meaningful. This paper presents a USES the monolithic integrated circuit AT89S52 control DS18B20 of the realization of the wireless temperature measuring system. Through the simple wireless communication protocol, realize the reliability and power balance, the system can realize to the temperature detection, can simultaneously determine the temperature, can be realized the wireless remote control temperature detection system. Low power consumption, real-time wireless temperature detection is the biggest characteristic of the design. Wireless transmission using nRF24L01 module transmission. The system structure is simple, reliable, low power consumption, low cost, it is a kind of wireless sensor solutions. Key word: MCU AT89S52 wireless transmission nRF24l01 DS18B20 目录 摘要 I Abstract II 目录 III 前言 1 1 系统方案分析与选择论证 3 1.1 系统方案设计 3 1.1.1 主控芯片方案 3 1.1.2 无线通信模块方案 3 1.1.3 温度传感