1-WCDMA无线技术.pptVIP

* * The primary scrambling code sequence, when transmitted on the air interface, is cut down to 38400 chips, which obviously corresponds to the duration of a single radio frame of 10 ms. In fact, the primary CPICH channel, which is exactly synchronised to the downlink radio frame borders, does contain the plain scrambling code. The data on the CPICH, before spreading with (256,0) consists of the sequence 1111. After spreading with (256,0), which is a sequence of 256 1 the CPICH data contains simply 38400 1 per frame before scrambling. The scrambling operation then does multiply the data chip by chip with the 38400 chips of the scrambling code word. Obviously, then the plain primary scrambling code is sent radio frame by radio frame of the P-CPICH. Since the receiver, after detection of the scrambling code group does know out of which set of 8 possible primary scrambling codes the scrambled data on the P-CPICH comes from, it can detect the used SC on the P-CPICH. * After all, the physical cell search process is completed after three steps: 1. Time slot synchronisation by P-SCH 2. Frame synchronisation and code group detection by S-SCH 3. Detection of primary scrambling code by P-CPICH Now the receiver can descramble the downlink signal and look for further code channels. Since it is known, that the P-CCPCH, containing the BCCH broadcast system information, is spreaded by (256,1) by default, the receiver can finally despread and read the required system information to complete the cell selection process. 第二步：帧同步和确定扰码组 第三步：确定扰码号 CPICH是预先定义的符号序列 扩频因子为256 (Cch,256,0) 采用主扰码进行加扰 UE根据确定的扰码族中的8个主扰码对CPICH进行解码，解码正确的主扰码即为该小区的主扰码 解码P-CCPCH信道获得广播消息 P-CCPCH包括当前的SFN和系统广播消息 P-CCPCH的扩频因子为256 (Cch,256,1) P-CCPCH用主扰码加扰 UE可以用主扰码对P-CCPCH承载的BCH信道进行解码，获得系统广播 谢谢！  * 问一下大家对3G的了解和概念 * * Data信息传输速率：2 Mbps for mobile speeds below 10 km/h, limited coverage 384 kbps for mobile speeds below 120 km/h, full coverage 144 kbps for mobile speeds below 500 km/h, full coverage 移动速度问题，I