CFRP压力容器固化成型过程中边界条件确定.pdfVIP

第 1 期 26　　　 纤 维 复 合 材 料 No 1 2007 年 3 月 FIBER COMPOSITES Mar ,2007 工艺研究 CFRP 压力容器固化成型过程中边界条件的确定 胡照会 ,王荣国 ,马 　李 ,刘文博 ( 哈尔滨工业大学复合材料研究所 ,哈尔滨 150001) 摘 　要 　文中应用总放热系数等效考虑了 CFRP 压力容器固化过程中热压釜辐射与对流边界条件 。将有限元法引 入瞬态热传导的反问题 ,根据试验测量的温度曲线 ,并结合最优化理论确定合理的热压釜热边界条件 。结果表明: 平板试验得到了总放热系数序列 ,其计算温度与测试温度的最大温差为 0. 147 ℃。由此 ,可以将得到的总放热系数 序列作为 CFRP 压力容器固化成型过程的等效热边界条件 ,为其固化成型的数值模拟提供计算基础 。 关键词 　热边界条件 ;反问题 ;有限元 ;优化理论 The Determination of Boundary Condition for CFRP Pressure Vessel during Curing Process HU Zhao - hui ,WANG Rong - guo , Ma Li ,LIU Wen - bo ( ) Center for Composite Materials Structures , Harbin Institute of Technology Harbin 150001 , China ABSTRACT 　General heat release coefficient is used to equivalently consider autoclave radiation and convection of boundary con dition during curing process for CFRP pressure vessel. To determine the reasonable heat boundary condition of autoclave , finite ele ment method is introduced to an inversion problem of transient heat conductivity with optimum theory and temperature curve mea sured in the test. The result reveals that general heat release coefficient sequence obtained in flat plate test , and maximum temper ature difference is 0. 147 ℃between calculated temperature and measured temperature. General heat release coefficient sequence is considered as equivalent heat boundary condition during curing process for CFRP pressure vessel and it provides calculated basis for the simulation of curing process. KEYWORDS 　Heat boundary