铁氧体磁轭零件精密磨削加工技术研究.docVIP

铁氧体磁轭零件精密磨削加工技术研究 学 院： 机械与车辆工程学院 专 业： 姓 名： 指导老师： 机械工程及自动化 马 宁 学 号： 职 称： 0604111039 王西彬、王宏甫 教 授 中国·珠海 二○一○年五月  毕业设计（论文）诚信承诺书 本人承诺呈交的毕业论文《铁氧体磁轭零件精密磨削加工技术研究》是在指导教师的指导下，独立开展研究取得的成果，文中引用他人的观点和材料，均在文后按顺序列出其参考文献，设计（论文）使用的数据真实可靠。 本人签名： 日期： 年 月 日 铁氧体磁轭零件精密磨削加工技术研究 摘 要 本文结合砂轮速度、磨削深度单因素和正交试验不同磨削参数对表面粗糙度优化了工艺参数并通过电镜观察磨削表面形貌磨削去除机理主要结论有工件速度磨削深度apap对其影响较小。 2）磨削工艺参数的改变对铁氧体表面显微硬度的影响并不显著，铁氧体磨削后显微硬度受磨削温度的影响较大，受磨削力的影响较小；在较低的砂轮磨削速度、较高的工件速度和磨削深度下，工件的显微硬度稍高。 3）铁氧体磨削表面主要由连续或不连续的切削痕迹，脆性断裂形成的凹坑以及塑性变形区构成；在较小工件速度磨削深度apTechnique of Precision Grinding on Ferrite Yoke Parts ABSTRACT In this thesis , the surface roughness, hardness, micro-defects of ferrite ceramic materials were studied, combined with grinding parameters such as wheel speed, grinding depth and workpiece speed and make use of the single factor and orthogonal tests of the different grinding parameters on the laws of surface roughness, hardness, micro-defects and so on. The process parameters were optimized to reduce the grinding surface roughness, for the basis of ferrite components grinding, grinding surface morphology of the ferrite was observation by electron microscopy and analyse the materials removal mechanism of grinding. 1）Ferrite grinding surface roughness Ra was smaller when the wheel grinding speed vs increase, and largen with the workpiece speed vw or grinding depth ap was increased, By the orthogonal tests can be seen that surface grinding in the grinding wheel speed vs and workpiece speed vw have greater impact on the surface roughness,but grinding depth ap was little. 2）Grinding process parameters effect on ferrite surface hardness is not significant, the hardness after grinding is greatly influenced by the grinding temperature, less affected by the grinding force. The higher hardness of the workpiece when the low wheel speed, higher workpiece speed and grinding depth. 3）Fe