模具设计与制造专业毕业论文--某机床注油孔冲压模具设计.docVIP

摘 要 本次毕业设计是完成注油口冲压工艺及模具设计。采用落料、拉深、冲孔、翻边、切边工艺。设计中分析了工件的冲压工艺性，计算了毛坯排样、冲压力、刃口尺寸计算等。进行了模具总体结构、主要零部件的设计，绘制了落料、拉深、冲孔复合模和翻边、切边的单工序模具装配图和零部件图。 冲压工艺 冲压模具设计 装配图 Abstract The graduation project is the completion of fuel injection port of a machine stamping process and die design. Use of blanking, drawing, piercing and flanging, trimming process. Analysis of the design process of stamping parts, calculate the rough layout, punch pressure, blade size calculation. The overall structure of the die, the main components of the design, drawing the blanking, drawing, piercing and flanging compound die, trimming a single mold assembly and parts operations plans In this paper, punch a hole all the machine injection mold process requires a brief introduction, and the mapping of the corresponding die assembly drawings, and the work of the various sets of mold and die design in the process of positioning, discharging a brief description of device . The topic for the mouth of a stamping machine oiling design difficulty is stretching the diameter of 180mm, depth 55mm deep hole. Need to stretch the hole stretch, zaifan hole, need to pay attention when the attention is to calculate the tensile deformation of plate, and malignant, a logical analysis and careful calculation to determine the stress deformation of the deformation degree of friction with the mold and the rough cylinder wall Carrying capacity, so as to avoid tube pieces crack. Need to focus on parts of the relative height h / d to determine the number of drawing, and the cylindrical deep drawing process dimensions of the detailed calculations Key Words: Press process Press tool design assembly diagram 目 录 注油口冲压设计 I Note hole in a stamping die design tool II 主 要 符 号 表 V 1 绪论 1 1.1冲压模的背景 1 1.2冲压模具制造技术几大发展趋势： 2 1.3冲压模研究的重点和难点 3 1.4论文的组织结构 4 2 工件的冲压工艺分析 5 2.1冲压件具体分析 5 2.2零件冲压工艺方案的确定 6 2.2.1工艺孔冲制方案 6 3 毛坯尺寸、拉深次数的计算及排样方式的选择 7 3.1计算毛坯尺寸 7 3.2按凸缘筒状形件的拉深 8 .3.3冲裁排样方式的设计及计算 10 4 模具设计及计算 11 4.1第一副模具（落料模）的设计及计算 11 4.1.2选择冲床时总冲