2015年模电大作业第二题复习.docVIP

模电大作业 学院：电子工程学院 第二题 一．题目重述 设计心电信号放大电路 要求：电路总增益60?80dB可调，输入阻抗≥1MΩ，共模抑制比KCMR≥80dB,带宽：0.1Hz?100Hz；电路具有50Hz陷波功能，陷波器中心衰减大于15dB。 提示： 1.输入级采用3运放构成的仪表放大器，可以保证输入阻抗和共模抑制比足够高。 2.陷波器可以采用带通滤波器和相加器组成的带阻滤波器或双T 带阻滤波器； 二．电路整体框图 三．前置放大电路 （1）思路 采用三运放的仪表放大器 （2）电路图 （3）放大倍数理论值 R1=R2=R3=R4; R5=R6; 放大倍数A1=-*(1+) RG为电位器，可在500欧姆到5000欧姆之间取值，则放大倍数为 40到400倍。 （4）放大倍数仿真结果 取R6为5000欧姆，则放大倍数为57.934\(-1.413)约为-40倍(32.249db)。 （5）共模抑制仿真结果 共模抑制电路图 共模抑制仿真结果 由上图可见共模放大倍数为1.5*10^(-7)倍。 共模抑制比最小为： ==5.3*10^8 结论：共模抑制比符合要求。 四．带通滤波与中级放大 （1）电路图 （2）理论值计算 FL=； 图中R1，C1的取值使FL为0.1hz。 FH=；图中R2，C2的取值使FH为100hz。 A=1+=25 （3）仿真结果 FL=0.101HZ; FH=100HZ; 放大倍数为27.95db(25倍) 五．陷波器电路 （1）电路图 （2）仿真结果 由图可知该电路可完成陷波功能 六．心电放大电路总图 （1）电路图 心电放大总图 （2）仿真结果 仿真结果图 由波特示意图看出，电路在50hz时滤波，当第一级的电位器选5k时，总的放大倍数为60.173db即1000倍，符合理论计算。 总结： 将三级电路级联。第一次放大40到400倍，第二次放大25倍，则共可以放大1000到10000倍。第二级滤波器频率范围是0.101hz到100hz，基本实现滤波功能。 RICHMOND — After hearing that Washington Redskins tight ends coach Sean McVay had been promoted to offensive coordinator in January, tight end Jordan Reed called McVay to offer his congratulations and ask a question. Reed and McVay grew close last season, and Reed wondered whether McVay would still have time for him. ?Can you believe that?” asked McVay, who smiled and shook his head while recalling the conversation Friday during a break from practice. “He actually thought I’d be too busy for him. You always make time for guys like him.” Jason Reid is a sports columnist with the Washington Post. He joined the Post’s Redskins team in 2007 after 15 years covering many beats at the Los Angeles Times. View Archive Google+ Especially if you’re an assistant coach who hopes to remain employed. Coach Jay Gruden has big plans for the young tight end, whose combination of size, speed — he’s listed at 6 feet 2, 237 pounds and covers the 40-yard dash in 4.7 seconds — a