STATEMENT FOR COMPLIANCE OF ARTICLES, PREPARATIONS HOMOGENEOUS MATERIALS规范.pdfVIP

Falco Electronics Me Falco Supplier Survey for Statement of Hazardous Materials Content 供应商材料有害物质含量调查声明 FSSHS, Rev. I1, 01/11/2013 STATEMENT FOR COMPLIANCE OF ARTICLES, PREPARATIONS HOMOGENEOUS MATERIALS /物品、配制品和同质材料符合声明 Material Designation and Manufacturer: 材料名称/制造商 EPOXY COMPOUND EPORITE 2066/EPOLAB CHEMICAL INDUSTRIES Color (Pigments, paints….) [1] 颜色(颜料,油漆……) Coating [1] 涂层 Pin/Tap/Clip [1] 引脚/末端/夹子 Over-Plating Alloy of Pin/Tap/Clip [1] 引脚/末端/夹子上的镀层 GRAY Instructions/指导： According to the substance name, CAS # and PPM content reported in the section MASTER or Amendment of this survey, Check only one box of the following Declaration of Compliance section below if the homogeneous material meets the respective Declaration of Compliance required. Also, please note thissection is mandatory and you must fill in after fill in the Master section properly. 根据调查表Master里面填写的物质名称，CAS#和ppm含量，如果同质材料满足下面的要求，选择相应的空格（每项 只能选一个）。注意，这一页未必填，必须在填完Master后填此页。 1.- Declaration of Compliance to RoHS Directive (Directive 2011/65/EC): // 符合RoHS指令的声明（指令 2011/65/EC ） A maximum concentration value of 0.1% (1000 PPM) by weight in homogeneous materials for Lead, Mercury, Hexavalent Chromium, Polybrominated Biphenyls (PBB) and Polybrominated Diphenyl Ethers (PBDE) and 0.01 % (100 PPM) by weight in homogeneous materials. // 铅、汞、六价铬、多溴联苯（PBB）、多溴联苯醚（PBDE）在同质材料中的重量含量最高为0.1% (1000 PPM)，镉的最高含量为0.01 % (100 PPM)。 complies with RoHS Directive 2011/65/EC and does NOT use any RoHS exemptions. 符合RoHS指令的声明（指令2011/65/EC ）并且没有用到任何RoHS豁免 complies with RoHS Directive 2011/65/EC and USES any of the RoHS exemptions listed in the table of Annex D. 符合RoHS指令的声明（指令 2011/65/EC ）并且有用到附件D中提到的RoHS豁免