混凝土专业方向毕业论文外文翻译.pdf

j o u r n a l o f m a t e r i a l s p r o c e s s i n g t e c h n o l o g y 2 0 9 ( 2 0 0 9 ) 767–773 j o u rn al h omepage: www.elsevi er.c om /locate/j matprotec Properties of the autoclaved aerated concrete produced from coal bottom ash a ˙ b b,∗ H. Kurama , I.B. Topc¸u , C. Karakurt a Eskis¸ehir Osmangazi University, Mining Engineering Department, Eskis¸ehir, Turkey b Eskis¸ehir Osmangazi University, Department of Civil Engineering, Eskis¸ehir, Turkey a r t i c l e i n f o a b s t r a c t Article history: This study examined the use of coal bottom ash (BA) from Tuncbilek Thermal Power Plant, Received 26 June 2007 Turkey, as an aggregate to produce aerated concrete. The BA was used as an aggregate Received in revised form with different replacement amounts. To determine the effect of ash incorporation on the 20 February 2008 final product properties, chemical, physical, mechanical, and microstructure analyses were Accepted 24 February 2008 performed. Results show that using BA in autoclaved aerated concrete (AAC) formulations caused a unit weight decrease in the produced AAC for all concerned BA replacement ratios. However, it was observed that for the concrete having 25% and 50% BA usage has also ben- Keywords: eficial effect on the strength gaining of the AAC. Thermal conductivity values reduced with Bottom ash increasing BA replacement ratio. Lightweight concrete