毕业设计论文-中型换热片用冲压模具设计.docVIP

摘 要 本论文根据产品图样，分析冲裁件的形状、特点、尺寸大小精度要求、表面质量及所用材料等冲压工世性，在此基础上，分别设计复合模 及压纹等单工序模具，实现流水线作业。流水线作业是本次设计的亮点所在。凸模采用成型加工或线切割，冲裁部分进行热处理，由螺钉固定，刚性推件，弹性卸料装置橡胶的弹性把料板由下而上推出，随上模的动作而动作，运动平稳可靠且不易损坏模具，采用中间导柱圆形有利用安装，且因安装不当而造成模具损坏，根据冲压力选择开式固定台压力机。 关键词：冲裁件；级进模；设计 Abstract The present paper basis product pattern, the analysis blanking shape, the characteristic, the size size precision request,the surface quality and use ramming labor world and so on the material, in this foundation, according to the superposable die the superposable die which was highly effective, high grade and so on the characteristic selects inverts, on, got down the waste material, the waste material discharges directly from the punch press Taiwan face,did not block, ease of operation, security. The top die uses the rubber, plays to the certain smooth role, improves the work piece quality, even reduces the working procedure. Has designed the convex-concave mold, the raised mold, the concave mold structure separately, the raised mold uses takes shape the processing or the line cuts, the blanking partially carries on the heat treatment, by the screw retention, the rigidity pushes, the elastic dumping device rubber elasticity from bootom to top promotes the yard lumber, but acts along with the top die movement, the movement steady reliable also is not easy to damage the mold among, uses the guide pillar circular to have the use installment, also because of does not install when but creates the mold damage, according to flushes the pressure to choose the type fixed platform press. Key word: Blanking Superposable die Design . 目 录 摘 要 I Abstract II 第一章 概述 1 1.1板式换热器的介绍 1 1.2国内外模具发展现状 2 第二章 散热片冲压工艺性能分析 5 2.1 散热片的介绍 5 2.2 散热片形状尺寸 5 2.3 散热片的工作原理 6 2.4 散热片尺寸及精度要求 6 2.5 散热片冲压工艺性分析 7 第三章 模具方案的分析确定 7 3.1 方案一 7 3.2 方案二 9 3.3 结论 11 第四章 模具设计 12 4.1 冲孔模模具设计 12 4.1.1 确定合理的冲裁间隙 13 4.1.2 冲压压力的计算 14 4.1.3 压力机的选择 14 4.1.4 凹凸模刃口尺寸的设计 15 4.1.5 冲模闭合高度的确定 15 4.1.6 螺栓选取和强度校核 15 4.1.7 销钉选取和强度校核 16 4.2 对称导柱压中间纹模具