汇编_C语言程序设计.pptVIP

汇编、C语言程序设计 例1 .equ x, 45 /* x=45 */ .equ y, 64 /*y=64 */ .equ stack_top, 0x1000 /*define the top address for stacks */ .global _start .text _start: /*code start */ mov sp, #stack_top mov r0, #x /*put x value into R0 */ str r0, [sp] /*save the value of R0 into stacks*/ mov r0, #y /*put y value into R0 */ ldr r1, [sp] /*read the data from stack,and put it into R1 */ add r0, r0, r1 str r0, [sp] stop: b stop /*end the code ，cycling */ .end 例2 .equ x, 45 /* x=45 */ .equ y, 64 /* y=64 */ .equ z, 87 /* z=87 */ .global _start .text _start: /* code start */ mov r0, #x /* put x value into R0*/ mov r0, r0, lsl #8 /* R0 = R0 8*/ mov r1, #y /* put y value into R1 */ add r2, r0, r1, lsr #1 /* R2 = (R11) + R0 */ mov sp, #0x1000 str r2, [sp] mov r0, #z /* put z value into R0 */ and r0, r0, #0xFF /* get low 8 bit from R0 */ mov r1, #y /* put y value into R1 */ add r2, r0, r1, lsr #1 /* R2 = (R11) + R0 */ ldr r0, [sp] /* 堆栈弹出到 R1 */ mov r1, #0x01 orr r0, r0, r1 mov r1, R2 /* put R2 value into R1 */ add r2, r0, r1, lsr #1 /* R2 = (R11) + R0 */ stop:b stop /* end the code ，cycling*/ .end 例3 子程序调用 .global _start .text .equ num, 2 /* Number of entries in jump table */ _start: mov r0, #0 /* set up the three parameters */ mov r1, #3 mov r2, #2 bl arithfunc /*call the function */ stop:b stop arithfunc: /*label the function */ cmp r0, #num /*Treat function code as unsigned integer */ bhs DoAdd /*If code is =2 then do operation 0*/ adr r3, JumpTable /*Load address of jump table */ ldr pc, [r3,r0,lsl#2] /*Jump to the appropriate routine */ 例3 子程序调用 JumpTable: .long DoAdd .long DoSub DoAdd: add r0, r1, r2 /*Operation 0, 1 */ mov pc, lr /* Return */ DoSub: Sub r0, r1, r2 /* Operation 1 */ mov pc,lr /* Return */ .end /*mark the end of this file */ Thumb指令 .global _start .text _start: .arm /*Subsequent instructions are ARM */ header: adr r0, Tstart+1/*Process