qt-extended4.4.3编译.docVIP

移植qtopia4手机版（qt-extended4.4.3）到mini2440的详细过程。。。。。。。。。 成功移植qtopia4.4.3手机版到mini2440上 首先说明:qtopia4是不能在源码目录中编译安装的，可以用configure—help查看。X86版和ARM版能不能使用同一个源码包（不用解压源码包qt-extended-opensource-src-4.4.3.tar.gz分别更名命*-src-x86和*-src-arm,只使用一个*-src即可？）这个没试过，应该是可以的，你们可以试试。我使用的分别解压到不同目录分别更名命*-src和*-src-arm （1）准备源码： qt-extended-opensource-src-4.4.3.tar.gz tslib-1.4.1.tar.bz2 （2)开发环境： Fedora9—linux-2.6.25 arm-linux-gcc-4.3.2.tgz （3) 先安装x86的qtopia手机版运行看看效果先： 1.)解压源码qt-extended-opensource-src-4.4.3.tar.gz到qtopia4目录中 2）创建目录build 和target [root@abilly qtopia4]# ls build target qt-extended-4.4.3-src 3)设置环境变量 [root@abilly qtopia4]# export QPEDIR=/home/abilly/qtopia4/build [root@abilly qtopia4]# export QTOPIA_DEPOT_PATH =/home/abilly/qtopia4/qt-extended-4.4.3-src [root@abilly qtopia4]# echo $QPEDIR /home/abilly/qtopia4/build [root@abilly qtopia4]# echo $QTOPIA_DEPOT_PATH /home/abilly/qtopia4/qt-extended-4.4.3-src 4)配置与编译，安装与运行 配置前可以到qt-extended-4.4.3下运行/configure –help看看选项说明 [root@abilly qt-extended-4.4.3]# ./configure --help 。。。。。。。 然后配置如下：进入build目录 [root@abilly build]# ../qt-extended-4.4.3-src/configure -build-qt -image /home/abilly/qtopia4/target -prefix /home/abilly/qtopia4/target ……（约2个半小时后） Qt Extended has been configured. You can build Qt Extended by running bin/qbuild. If you run bin/qbuild image, this will setup a runnable image in /home/abilly/qtopia4/target. As configured, Qt Extended MUST be run from /home/abilly/qtopia4/target. If this is not where you intend to run Qt Extended from you should set the location by running configure -prefix /opt/Qtopia. You have new mail in /var/spool/mail/root 配置成功 编译： [root@abilly build]# bin/qbuild ……（约5个小时后） Qt Extended has been built. You must now install Qt Extended by running bin/qbuild image. This will put the files required to run Qt Extended into the image: /home/abilly/qtopia4/target Before you can use the SDK you must finalize it by running bin/qbuild sdk. This will put the required files into