模具设计与制造专业英语 教学课件 黄义俊电子教案统一模板(模具)Unit5.pptVIP

Unit 5 The Parts for Dies and Molds Unit 5 The Parts for Dies and Molds 5.1 Lesson 10 Die Part—Stock Stop Figure 5-1 Adjustable block stop for a blanking die 1—Adjustable solid block stop 2—Support bar There are several kinds of stock stops in the various dies. A stock stop may be a pin or small block against which an edge of the previously blanked opening is pushed after each stroke of the press. With sufficient clearance in the stock channel, the stock is momentarily lifted by its clinging to the punch, and is thus released from the stop. Figure 5-1 shows an adjus