Pyro2(2750D)_Instramp;Class_29DEC06_JE-高温测量-仪器设备.ppt

1500 1501 Multipoint Chart Recorder (Working Instrument) High Limit Device (Recommended) Furnace Controller (Working instrument) Furnace wall or heating element Sand Seal Retort Furnace Control T/C (Working Sensor) High Limit T/C (Sensor) Part or Raw Material Load T/C (Working Sensor) Load Sensor Part or Raw Material Over-Temp Sensor Controller Instrument) Furnace Wall or Heating Element Control Sensor Sand Seal Retort Over-Temp Protection (Required) Chart Recorder Type B InstrumentationRetort Furnace Control Instrument Control Sensor Temperature Display Recording Instrument(s) Minimum of One Recording Load Sensor Over Temperature Protection 63 Heat Treating Task Group Audit Handbook Released: November 8, 2006 PERFORMANCE REVIEW INSTITUTE 161 THORNHILL ROAD WARRENDALE, PA 15086-7527 724-772-1616 Available at eAuditNet, Public Documents 64 AMS 2750D, Page 9/10 31 AMS 2750D, Page 9/10 32 Sticker(s) with: Date the calibration was performed. Due date of the next calibration. Technician who performed the calibration. Any limitations or restrictions of the calibration. Note: Example shows a sticker for both the controller and recorder. 33 AMS 2750D, Page 10/11 34 AMS 2750D, Page 11 35 Additional Auditor Items The auditor will also check: Chart paper alignment (digital recorder reading as compared to the chart paper marking). The time stamping of charts (self-printing time function). 36 Thermal Processing Equipment 37 AMS 2750D Categorization of thermal processing equipment. AMS 2750D requires that all thermal processing equipment be identified for Class and Instrumentation Type. The method for categorizing thermal processing equipment has been changed significantly from that required by AMS 2750C. 38 The Old Method - AMS 2750C AMS 2750C. Required that all furnaces be identified for the following: Class. Type. Usage code. Sometimes difficult to interpret and apply. 39 The Old Method - AMS 2750C The furnace Class - 1 or 2 (3.3.1). Class (1 or 2) wa