毕业论文hhf.docVIP

摘 要 在声波测井中，常常会因为地层的衰减，使得声波测井仪无法接收声波的首波信号。为了增强接收的声波信号，通常采用两种方法：一是通过增大换能器尺寸来降低声波的频率从而减小地层衰减；二是增大换能器的发射功率来增大声波信号的功率，但是由于换能器所能承受的最大激发电压和温度的限制，致使发射声信号功率有限。所以，可以通过相控阵技术使阵列发射探头发出的声信号同相位叠加，改善指向性达到增强首波信号的目的。阵列声波测井仪有两种组成方式：一是单接收器和一维阵列声源的组合；二是单声源和一维阵列接收器的组合。换能器为薄圆管形压电换能器。本文采用了声波测井中的传输网络理论与指向性权系数的概念，推导出了换能器的几何形状与尺寸对线阵声源的导向系数的关系。通过改变阵列接收器接收到的声波信号的时间偏移量和线阵声源的激发延迟时间，可以令接收的首波幅度（阵列声源）与叠加波的首波幅度（阵列接收器）达到最大。通过本文提出的方法可以令声波测井中接收到的声波测井信号的首波幅度大大增加。 关键词：阵列声波测井、相控阵、指向性、换能器、激发延迟时间 Abstract In acoustic logging, often because of the decline of formation makes sonic tool cannot receive the first wave of sound wave signal. In order to enhance the received acoustic signal, usually adopts two methods: one is through increased to reduce the frequency of the acoustic transducer dimension reducing formation attenuation; Second is to increase the transmission power of the transducer to increase the acoustic signal of power, but because of the transducer can bear the limit of maximum excitation voltage and temperature, the sound emission signal power co., LTD. So can make through phased array technology emission probe array acoustic signals with the phase superposition, achieve the enhancement purpose to the first wave signal to improve the directivity. Array acoustic logging tool is composed of two ways: one is the combination of single receiver and a one-dimensional array source; The second is simple sound source and the combination of a one-dimensional array receiver. Transducer is a thin circular tube in the shape of a piezoelectric transducer. This paper adopts the transmission network theory and directivity of acoustic logging weight coefficient, the concept of the geometric shape and size of the transducer is deduced on the relationship between the linear array direction Guide coefficient of sound source. By changing the array receiver to receive the time offset and linear array acoustic signal source excitation delay time, can receive the first wave of sound source (array) and superposition