基于SHT11的温室多点测量系统设计_樊建明.pdfVIP

25 11 Vol. 25, No . 11 2006 11 Foreign Electronic Measurement Technology Nov. , 2006 SHT11 樊建明 陈渊睿 ( 华南理工大学 广州5106 0) : 温室内要实现温湿度的精确控制必须进 多点测量基于这一要求, 本文采用多 个数字温 湿度传感器SH T 11 来设计温室测量系统, 以达到简化软硬件系统设计, 提高测量精度的目的首 先介绍了SHT 11 的结构特点接口电路和工作时序, 然后确定了采用多 个SHT 11 组成的温湿度测 量系统的软硬件设计方案, 最后基于AT89S52 单片机设计了电路简洁大大节省I/ O 口资源具有 现场独立显示和远距离通信功能的多点温湿度测量系统, 并编写了PC 机端直观的数据观测界面程 序, 为现代化温室的集中管理提供了条件 : SHT 11 温室多点测量系统 单片机 Design of greenhouse multi-points measuring system based on SHT11 Fan Jianming Chen Yuanrui ( S out h Chi na Univ ers i ty of T ec hnol ogy , G uangd ong 5106 0) Abstract: Multi-points measuring is necessary for greenhouses exact temperature humidity con- trolling system. For this reason, w e use several digital temperature humidity sensors to design the greenhouse measuring system, It can make the softw are and hardw are designing easier and the measuring precision higher. Firstly , the paper, introduces SHT 11s structure characters, I/ O con- necting circuit and w orking schedual. T he scheme that how to design the softw are and hardw are of temperature humidity measuring system by using several SHT 11 is presented. Finally , A tem- perature humidity measuring system based on AT89S52 is designed. The advantages of the sys- tem are simple hardw are, less I/ O resource, self-displaying and long distance communication. Fur- thermore, A data observating interface in the PC terminal is programmed, w hich can provide a good condition for concentrative management of modern greenhouse. Keywords: SHT 11, greenhouse mult-i points measuring system, single chip , 0