毕业设计（论文）-基于单片机系统的多路数据采集控制器的设计.docVIP

浙江理工大学 科技与艺术学院 毕业论文诚信声明 我谨在此保证：本人所写的毕业论文，凡引用他人的研究成果均已在参考文献或注释中列出。论文主体均由本人独立完成，没有抄袭、剽窃他人已经发表或未发表的研究成果行为。如出现以上违反知识产权的情况，本人愿意承担相应的责任。 声明人（签名）： 年 月 日摘 要 本文就基于单片机系统的多路数据采集控制器的设计进行阐述，数据采集系统是模拟域和数字域之间必不可少的纽带。本文详细论述了数据采集系统的工作原理，及各种元器件和设计方案的选择。通过对数据采集的工作原理的分析和方案的比对，选择合理的方案，来达到各个功能模块的实现。 设计了一种采用51单片机为核心来实现多路数据采集控制器的方案。该方案将8路被测电压通过ADC0809模数转换来实现对采集到的数据进行模拟量到数字量的转换，然后由单片机对数据进行处理，最后对处理完的数据进行多种形式的显示。一种是把数据直接在数码管上显示，另一种是把数据通过DAC0832进行转换后通过示波器进行显示，以及通过8盏LED小灯来显示控制功能。 最后，本文描述了在多通道数据采集控制器硬件实现后，整体性能的调试过程，并希望对本方案能有更好的改进。 由于时间的限制及其本人的水平有限 D/A转换；A/D转换；AT89C51；LED Abstract In this paper, based on the single chip microcomputer system for multi-channel data acquisition controller design of, data acquisition system is the analog domain and digital domain between essential link. This paper discusses in detail the working principle of data acquisition system and a variety of components and the selection of design scheme. Based on the data acquisition principle of work analysis and scheme comparison, reasonable selection of scheme, to achieve the realization of various functional modules. Design of a51 single chip microcomputer as the core to achieve multi-channel data acquisition controller scheme. The program will be8the voltage to be measured through the ADC0809conversion to achieve the data was collected and analog to digital conversion, then by the single-chip microcomputer for data processing, the processed data to carry out various forms of display, at the end of the processed data to carry out various forms of display. One is to put the data directly in the digital tube display, another is to use the data through DAC0832converted through the oscilloscope display, and by8LED lights to display control function. Finally, this paper describes the multi channel data acquisition controller hardware implementation, the overall performance of the debugging process, and they hope to this scheme can have better improvement. Due to time constraints and its own level is limited