机械毕业设计（论文）-300米履带式液压水井钻机设计【全套图纸】.doc

摘 要 采用履带式关键词： 全套图纸，加153893706 Abstract This graduation project primary mission is designs a 300 meter marching hydraulic pressure water well drilling machine, the drill hole caliber is 152-305mm.The entire drilling machine design mainly by the power head, the drill tower, the chassis, the caterpillar band walks part and so on organization and hydraulic system designs is composed. With formerly was common the drilling machine to compare, this design 300 meters dived the water well drilling machine to use the marching hydraulic pressure actuation undercarriage system, the motion are more flexible, could adapt and so on moistly the adverse circumstance. The power head main body structure also did modified greatly, lengthens the main axle service life, the power head has used the whole fluctuation structural style, when picked up and unload the drill rod the effective protection attachment thread, reduced the drill rod damage. This article studies mainly is the power head part design. The power head part also is the entire drilling machine most important part, but the gear and the main axle design relates the entire power head the service condition, therefore in the article the counter gear and the main axle have carried on the detailed examination computation, the main axle terminal seal also are a this design key point, mainly manifests in from in the tight seal packing collar design. The box body uses the steel plate welding manner to make, in satisfies the operation requirements under the premise, but also reduced the production cost. Keyword：Gear design; From tight seal; Intensity examination目 录 I Abstract II 1绪 论 1 1.1水井钻探概述 1 1.2冲击回转转进简介 4 1.3动力头式钻机简介 5 2设计技术要求 11 2.1设计原始数据 11 2.2设备的工作环境 11 2.3设计要求 11 3钻机的总体方案设计 12 3.1动力装置的选择 12 3.2传动系统的选择 13 3.3钻机的总体布置 13 4动力头整体分析 16 4.1主要参数的确定 16 4.2结构方案设计 16 5动力头部件设计 20 5.1液压马达选型 20 5.2计算传动比 22 5.3计算传动装置的运动和动力参数 22 5.4齿轮的设计 23 5.5主轴的设计 32 5.6键的设计与校核 39 5.7轴承端盖的设计 40 5.8轴承的选择及强度校核 41 5.9动力头箱体的设计 46 5.10密封设计 47 5.11其他附件的选