毕业设计（论文）-实验设备电源无线控制系统.doc

本科学生毕业设计 实验设备电源无线控制系统 院系名称： 专业班级： 学生姓名： 指导教师： 职 称： 二一二年六月 The Graduation Design for Bachelors Degree Laboratory quipment Power Wireless Control System Candidate：Specialty： Class： Supervisor： Heilongjiang Institute of Technology 2012-06·Harbin  摘要本设计是基于单片机实现对实验设备的无线控制系统。本设计分为无线模块PT2262/PT2272编码电路、电源开关及单片机控制部分。本设计通过无线电实现控制信号的传递，单片机作为控制部件协调处理整个系统的工作。 关键词：单片机无线收发系统电源开PT2262/PT2272；LM358  ABSTRACT The power supply is essential in everyday life, whether home, office, or shopping malls and other places need electricity are inseparable from it. Currently on the market, most of the power supply are wired, usually you can also, in a multi-user centralized control applications, the use of wired switches focus to control each users power switch (such as student dormitories, intelligent community, school computer room and experimental room), raw materials and construction, it will be a lot of money. Moreover, from the overall aesthetic appearance of the project is concerned, it is not beautiful, if the power of wireless control, you can save a lot of expenses and reduce some unnecessary trouble. The design is based on single chip wireless control system for laboratory equipment. The design uses a remote control switch to the 315MHz frequency stabilization of radio-controlled components and other peripheral components assembled. Microcontroller can control a variety of laboratory equipment. The design is divided into the wireless module PT2262/PT2272 coding circuits, power switch and microcontroller control section. The MCU sends the corresponding control signal sent to the data input of PT2262. By the PT2262 encoding and modulation in 315MHZ carrier, antenna out after a high-frequency amplification. Then the signal received by the receiver board, after two LM358 high-gain amplification into the PT2272 to decode the output sent to the microcontroller, the microcontroller according to the operation signal to control the corresponding electrical contr