毕业设计（论文）-自动吹瓶机设计.docVIP

聊城大学东昌学院 本科生毕业论文（设计） 题 目： 自动吹瓶机设计 专业代码： 080251 作者姓名： 学 号： 单 位： 聊城大学东昌学院 指导教师： 2012年 5月8日 目 录 前言 3 课题的背景 3 课题的意义 4 1.整体方案的确定 6 1.1中空成型分类 6 1.2工作原理及主要构成 7 1.2.1 工作原理 7 1.2.2 主要构成 7 1.2.3 双工位挤出吹塑中空成型机 8 1.3整体方案确定 9 2.挤出机的选用 10 2.1 挤出机机组的主要构成 10 2.2 塑料挤出机的分类 13 2.3型号的选择 13 3.机头及其零件设计 14 3.1机头分类 14 3.2 机头的结构设计 15 4.合模与吹气机构设计 18 4.1 导向与合模机构 18 4.2吹气装置 19 5.机架和导轨的设计及计算 21 5.1 机架的设计计算 21 5.2 导轨的设计计算 23 结 论 25 参考文献 26 致 谢 27 摘 要 Abstract This paper focuses on the blowing machine design, molding plastic parts it is an important technique and equipment. Extrusion blow molding is the use of hollow plastic extrusion and can be molded so that the state of viscous flow of the plastic (in the extruder screwmea-surement above) under the action of the screw through the nose to obtain wall thickness wall thickness manufactured by the same or the shape of the governing law of the distribution of embryos. Mobile 2 Die Die tube embryos to be caught, and tube cutter to cut off the embryo. Embryo cut in the pipe must be carried out before the pre-blowing, and its main purpose is to prevent the adhesion between the wall tube embryos. Die inflatable device after I sealed tube embryos, while the gas insufflation pressure, so that in the viscoelastic state of the type embryos die close to the inner wall cavity, the two separate half-module, that is, to obtain the necessary products hollow. In accordance with its technical requirements and application requirements, select the type of PVC plastic, and then based on the shape of plastic and production volume, select the SJ-120 Plastic Extruder.  Here the design of plastic molding machine for single-layer, single-mode hollow extrusion blow molding machine. In determining the structure of the program machine after machine assembly drawing and calculation. Finally, non-standard parts forming machines drawn map, a full assessment by the manufacturer after