模具英语17.docVIP

模具工程常用词汇 die 模具die shoe 模瓦figure file, chart file 图档cutting die, blanking die冲模progressive die, follow (-on)die 连续模compound die 复合模punched hole 冲孔panel board 镶块to cutedges=side cut=side scrap 切边to bending 折弯to pull, to stretch 拉伸Line streching, line pulling 线拉伸engraving, to engrave 刻印upsiding down edges 翻边to stake 铆合design modification 设计变化die block 模块folded block 折弯块sliding block 滑块location pin 定位销lifting pin 顶料销die plate, front board 模板padding block 垫块stepping bar 垫条upper die base 上模lower die base 下模座upper supporting blank 上承板upper padding plate blank 上垫板spare dies 模具备品spring 弹簧bolt 螺栓plate 电镀mold 成型material for engineering mold testing 工程试模材料not included in physical inventory 不列入盘点incoming material to be inspected 进货待验PCE assembly production schedule sheet PCE 组装厂生产排配表model 机锺work order 工令revision 版次production control confirmation 生产确认checked by 初审approved by 核准stock age analysis sheet 库存货龄分析表on-hand inventory 现有库存available material 良品可使用obsolete material 良品已呆滞to be inspected or reworked 待验或重工cause description 原因说明part number/ P/N 料号item/group/class 类别prepared by 制year-end physical inventory difference analysis sheet 年终盘点差异分析表physical inventory 盘点数量physical count quantity 帐面数量difference quantity 差异good product/accepted goods/ accepted parts/good parts 良品defective product/non-good parts 不良品disposed goods 处理品on way location 在途仓oversea location 海外仓spare parts physical inventory list 备品盘点清单spare molds location 模具备品仓skid/pallet 栈板tox machine 自铆机wire EDM 线割 EDM 放电机coil stock 卷料sheet stock 片料tolerance 工差score=groove 压线cam block 滑块pilot 导正筒trim 剪外边pierce 剪内边drag form 压锻差pocket for the punch head 挂钩槽slug hole 废料孔feature die 公母模expansion dwg 展开图radius 半径shim(wedge) 楔子torch-flame cut 火焰切割set screw 止付螺丝form block 折刀stop pin 定位销round pierce punch=die button 圆冲子shape punch=die insert 异形子stock locater block 定位块under cut=scrap chopper 清角active plate 活动板baffle plate 挡块cover plate 盖板male di