管理Cisco设备-标度IP实验室.pptVIP

Slide 1 of 4 Purpose: Emphasize: When copying to RAM, it is always a merge not an overwrite. Explain on the board the difference between a merge versus an overwrite. Explain the general syntax of the copy command: copy from to With 12.0, the copy command supports a new syntax. The new syntax is explained in a later slide. Slide 2 of 4 Purpose: Emphasize: Slide 3 of 4 Purpose: Emphasize: Note: The Cisco TFTP server software which runs on Windows 95/98/NT can be downloaded from the url listed below: /cgi-bin/tablebuild.pl/tftp A Cisco router can also be configured to be a tftp server using the “tftp-server” global configuration command. Slide 4 of 4 Purpose: Emphasize: Slide 1 of 1 Purpose: Emphasize: Note: Release 12.0 supports new syntax for the “copy” command. Slide 1 of 1 Purpose: Emphasize: This section introduces topics on managing your configuration file and IOS image. Slide 1 of 4 Purpose: This slide establishes an overview and reason to use the TFTP server as a load source or backup destination for Cisco IOS software. It then presents the preparation details needed before executing TFTP copies. Emphasize: Geographically distributed routers need a source or backup location for software images. Using a network server allows image and configuration uploads and downloads over the network. The network server can be another router, a workstation, or a host system. A router can be configured as a tftp server using the tftp-server global configuration command. Layer one - First, you need to check that you have access to the network server. Example, use the ping command to see if you can reach the server. Slide 2 of 4 Purpose: Emphasize: Layer 2 — you need to check that you have enough disk space on the tftp server to house the new system image. On the router, use the show flash command to determine the length of the IOS image. Slide 2 of 4 Purpose: Emphasize: Layer 3 — you need to check the naming conventions required on the server. Example, what is the max