高精密平板流延机结构设计.doc

沈阳理工大学 毕业设计(论文) 平板流延机结构设计 所在学院 专 业 班 级 姓 名 学 号 指导老师 年 月 日 摘 要 本次设计是对的设计。主要包括:系统的设计、系统的设计、、的设计这次毕业设计对设计工作的基本技能的训练，提高了分析和解决工程技术问题的能力，并为进行一般机械的设计创造了一定条件设计滚珠丝杠Abstract This design is the design of slab casting machine. Here mainly includes: the horizontal screw drive system design, the vertical screw drive system design, casting head transmission design, vacuum chuck vacuum fixture design. The graduation design on the design of the basic skills training, enhancing the analysis and to solve engineering problems, and create a certain condition for general mechanical design. The structure is mainly produced by the motor power through the coupling will need to transfer the power to the screw rod, the screw rod drives the screw rod nut, which drives the motion, design of casting machine in the area of 300X300mm slab casting machine. Slab casting machine but also show its superiority, there are broad prospects for the development. The research of this thesis: (1) the overall structure design of slab casting machine. (2) analysis of slab casting machine performance. (3) the choice of motor. (4) the design of transmission system, executive components of plate casting machine. (5) the design of components for the design calculation and check. (6) to draw the assembly drawing and parts assembly diagram and parts diagram design. Keywords: slab casting machine, coupling, ball screw 目 录 摘 要 II Abstract III 目 录 IV 1 绪论 1 1.1 流延机的历史及现状 1 1.2 我国流延机的特点 2 1.3 本课题研究的内容及方法 2 1.3.1 主要的研究内容 2 1.3.2 设计要求 3 2 总体方案机构设计 4 2.1 设计内容及要求 4 2.2 设计方案 4 3 水平方向进给机构结构及传动设计 6 3.1 滚珠丝杆副的设计 6 3.2 滚珠丝杠选择 7 3.3 滚珠丝杠支承选择 9 3.4 滚珠丝杠螺母副间隙消除和预紧 10 3.5 伺服电机选择 11 3.6 直线滚动导轨副的计算、选择 18 4 竖直方向进给传动系统的设计和计算 21 4.1 进给伺服系统的设计 21 4.1.1 对进给伺服系统的基本要求 21 4.1.2 进给伺服系统的设计要求 21 4.1.3 进给伺服系统的动态响应特性及伺服性能分析 22 4.2 竖直滚珠丝杠副计算与选择 22 4.3 竖直进给步进电机计算 27 4.4 导轨副的计算、选择 30 4.5 联轴器的选择 32 5 流延头机构设计 33 5.1 电机的选取 33 5.2 轴的设计 35 5.3 轴的校核 36 5.4 键的校核 37 5.5 轴承的校核 38 6 真空夹具设计 40 6.