PHSM466 HAND STAND MIXER DFC.xls

Problem record pp sample report Report form english chinese LIMITATION: THE SELECTION OR USE OF ANY AQL SHALL NOT IMPLY THAT THE CONTRACTOR HAS THE RIGHT TO SUPPLY ANY DEFECTIVE UNIT OF PRODUCT. Approved By: DESCRIPTION OF DEFECT MIN MAJ CRI DEFECT CLASSIFICATION ACCEPTANCE QUALITY LEVEL: Description: Manufacturer: (AQL) FOR DEFECTS: SINGLE NORMAL, Level II SAMPLING PLAN: Level II Model/Item #: Revision Date: CRITICAL: MAJOR: MINOR: PACKING SAFETY APPEARANCE A. Safety related FUNCTIONAL WORKMANSHIP B. Non-safety related X TOWN. DONG GUAN CITY, GUANGDONG PROVINCE,CHINA. 523850????????? Tel: (86)-769 CRITICAL DEFECT: A CRITICAL DEFECT is a defect that judgment and experience indicate would result in hazardous or unsafe conditions for individuals using or maintaining a product. Also, depending on the product, a defect that judgment and experience indic SOURCE ONE LIMITED 5TH, BLOCK A,LUCK COMMERCIAL BULIDING, XINAN ROAD, CHANG AN ????????? Email address: Ryanlo@ Yan@ MIL-STD-105E MAJOR DEFECT: A MAJOR DEFECT is a defect, other than critical, which is likely to result in failure and/or reduce materially the usability of the product for its intended purpose. MINOR DEFECT: A MINOR DEFECT is a defect that is not likely to reduce materially the usability of product for its intended purpose. Date: CRI MAJ MIN X SAFETY 螺丝滑牙 产品不平晃动 A. 影响到安全 B. 跟安全无关 机内有金属部件松脱 电源线接线端子松，存在安全问题的 内部导线没有在合适的位置捆扎 Prepared By: 死机或不能正常工作 A) 超过 1.0mm B) 大于 0.5 mm and 小于 1.0 mm 特殊要求测试 X 丝印吸附力测试(3M胶带） Plastic bags must have holes and warning language Appearance design Assembly requirements Internal structure Plug Power cord 5TH, BLOCK A,LUCK COMMERCIAL BULIDING, XINAN ROAD, CHANG AN ????????? Email address: Yan@ INSPECTION REPORT Final Random Inspection On: Inspection Date: Supplier: PO No.: Model No.: Inspection Result: Inspection By: Order Quantity Sample Size Packed Not Packed Not finished Qty MIL-STD-105E: Si