基于CFD的离心式气_液分离器结构设计及仿真优化_张慢来.pdfVIP

2008 37 51 50 O L F ELD EQU PMENT 2008, 37( 10) : 50~ 55 :2008) CFD , ( , 434023) :运用CFD 技术优化设计了一种新型离心式气液分离器, 以去除气侵钻井液中的小气泡通 CFD 模拟, 研究分析了该分离器内湍流状态下的2 相流动, 以及分层分离旋流等复杂现象 模拟结果显示, 由于分离器内的运动部件 转鼓旋转,钻井液形成强迫旋流, 不同密度的气液相 在离心力作用下发生分离试验测试结果表明, 该分离器试验模型的分离性能显著稳定, 保证了 钻井液性能尤其是密度的稳定, 从而验证了CFD 的有效性在内流场分析的基础上, 对分离器试 验模型进行仿真优化, 改进了入口方式和转鼓结构结果表明, 切向入口有利于改善来液的流动; 分离器增加 1 个旁通管形成循环支路后,有利于降低背压, 使排气管壁上的液滴流回到分离器 : 离心式气液分离器;2 相流动;转鼓; 分离性能 : TE931. 102 : Design and Simulation Optimization of Centrifugal Gasliquid Separation Based on CFD ZH NG Manlai,FENG Jin ( Col leg e of Mechan ical E ng ineer ing , Yang tz e Un iv er sity , J ingz hou 434023, Ch ina) Abstract: With the technology of CFD, a new kind of centrifugal gasliquid separation is designed and optimized to separate gas entrained in drilling fluid. T he centrifugal separator has an upper fluidinlet, an upper gasoutlet, and the bottom is a fluidoutlet. In this separator, a rotary drum mounted to a rotating shaft is driven by a motor. T hrough CFD simulation, the turbulent two phase flow in the separator is studied, and the complex phenomenon of layer, separation, and swirl is especially discussed. T he simulation result shows that a forced vortex is formed during rotary drum rotating, and gasliquid twophase with different density is separated under centrifu gal function. Furthermore, the separation efficiency of the produced experimental separator is tested, and it indicates that the centrifugal gasliquid separator performs steadily and efficiently, thus the validity of CFD is verified. In addition, on the basis of analyzing inner flow field, simu lation optimization of ex