抽油杆盘根密封机理研究.pdfVIP

2008 37 3 29 OIL FI LD QUIPM NT 2008,37( 3) :29~ 32 : 1001-3482(2008)03-0029-04 1 1 2 1 1 , , , , ( 1. , 610500; 2. , 834000) :有杆抽油系统的井口盘根密封性能与密封面的接触压力分布和大小密切相关,研究 规律至 关重要通过系统接触有限元分析方法,用 ANSYS 参数化设计语言编写了盘根密封有限元分析 的命令流程序, 研究了不同参数值下的密封压力分布结果表明, 密封面上的压力分布呈驼峰形 式,盘根变形存在/ 向心0效应等,与试验结果 一致;盘根与光杆的间隙增加会导致密封效果降低;盘 根的轴向尺寸增加将导致密封效果先降低然后增加,因此必须优选该尺寸;盘根径向尺寸的增加会 导致密封效果下降, 应合理选择 : 盘根;密封;有限元;抽油杆;机理 : TE933.2 : A Study of Sealing Mechanism of Sucker Rod Packer 1 1 2 1 1 GUO Li-xiao , U Ka-i song ,YUAN Xin-sheng ,ZHAI Zh-imao ,YU Chang-bo ( 1. Colleg e of Mechanical and E lectronic Eng ineering , S outhw est Petroleum University, Chengdu 610500, China; 2. X inj iang Petroleum d ministration, K elamayi 834000, China) Abstract: The packing sealing performance of the well head is closely related with the contact pressure, size and distribution in the sucker rod system, so it is important to study the rules of the contact pressure in the sealedface. The order flow procedures by the ANSYS Parametric De- sign Language of the Finite Element Methods were compiled in this article. The distribution of the sealing contact pressure inthe different valuesof the parameterswas carriedout. The results show the rules that the contact pressure on the sealface is hump shape and there is a centripetal effect in the packing distortionconformedto theresultsof experiment. henthegap between the packing and the rod increased, the seal effect would be reduced. The increase of the axis-dimen- sion of the packing will lead to theseal effect to reduce at first,