循环荷载作用下脆性材料剪切性能试验研究.pdfVIP

第26 卷 第3 期 岩石力学与工程学报 Vol.26 No.3 2007 年3 月 Chinese Journal of Rock Mechanics and Engineering March 2007 循环荷载作用下脆性材料剪切性能试验研究 周秋景 李同春 宫必宁 (河海大学 水利水电工程学院 江苏 南京 210098) 摘要 在自制的MTS 振动台试验设备上对混凝土 岩石类脆性材料(砂浆材料)进行静力和动力剪切试验 试验结 果表明 (1) 动力荷载情况下位移–剪力包络线形状同静力荷载情况下曲线破坏形状相似 均可划分为相同的 4 个阶段 (2) 在相同垂直压力作用下试件的动力抗剪强度与静力抗剪强度相比有明显的增大趋势 强度较低的试 件强度增加较大 (3) 在相同频率情况下 随着垂直压力的增大 峰值剪切强度 残余抗剪强度随之增大 (4) 静 力荷载情况下其破坏处水平位移要大于动力荷载情况下破坏处的水平位移 其他条件相同时破坏处水平位移值随 峰值抗剪强度的增大而增大 (5) 剪切过程中有明显的剪胀现象出现 最后根据试件的破坏形状 初步分析混凝土 岩石类脆性材料的动静态剪切特性的机制 关键词 岩石力学 动力剪切试验 脆性材料 剪切性能 + 中图分类号 TU 45 TD 315 .3 文献标识码 A 文章编号 1000 –6915(2007)03 –0573 –07 EXPERIMENTAL STUDY ON SHEAR BEHAVIORS OF BRITTLE MATERIALS UNDER CYCLIC LOADING ZHOU Qiujing LI Tongchun GONG Bining (College of Water Conservancy and Hydropower Engineering Hohai University Nanjing Jiangsu 210098 China) Abstract Shear tests under static and cyclic loadings were performed with direct shear equipment in order to explore the shear behaviors of brittle materials such as concrete rock etc. under different loadings. The direct shear equipment that allows static and dynamic shear tests was designed based on MTS in the Vibration Laboratory of Hohai University and brittle materials were modeled by mortar. Test results under static and cyclic loadings including 1 2 3 and 5 Hz show (1) shear stress-displacement curves under static loading are similar to the strength envelope curves under cyclic loading that can be divided into four parts (2) the peak strength and residual strength under cyclic loading are larger than those unde