CX系列writecache无法enable解决方法之一.pdfVIP

CX writecache enable CX writecache enable CCXX系列产品wwrriitteeccaacchhee无法正常eennaabbllee解决方法之一 前期完成了一套CX3-10C设备（单SPS配置）安装，正常情况下当SPS充满电后，write cache会自动enable，但这次不成功，在做过多次尝试：更换电池监控线、更换SPS、更换 连接控制器、升级控制器微码等操作不成功后，根据 EMC800的判断，做了如下工作，即 设置成功，具体如下： In the mean time since there is no Data on the array it seems safe to try the solution provided in Primus EMC60614 see below for details. Regards, EMC SW: Navisphere 6.x Standby power supplies (SPSs) fully charged and cabled to the storage processors (SPs). EMC Firmware: FLARE 02.02.1.60.5.003 Cannot enable write cache on newly installed CX600 array CRU signature errors after swapping drives Error code 0x66a: Soft Vault Load Failure Error code 0x951: CRU Signature Error on one of the 5 vault drives ( 0_0, 0_1, 0_2, 0_3 or 0_4) in SP event logs Cannot complete a test vault dump when trying to enable write cache Unbound all LUNs and then bound a small LUN but CRU signature error persists. Drives from the first five slots of the DAE-OS were swapped into another CX600 DAE-OS and then put back into their correct positions on the original array. Cache will not enable if either of the two errors (CRU signature or soft vault load failure) are in the event logs. When write cache is enabled, FLARE performs a test. In one case, the test failed causing write cache to be disabled. Swapping the drives from the first five slots of the DAE-OS, even when put back, will cause problems as revealed by CRU signature errors from the swapped drives whenever the array is rebooted. Errors like the following from one array were reported: 11/15/2002 07:40:59 Enclosure 0 Disk 3 (951) CRU Signature Error [0x01] 0 0 11/15/2002 07:40:59 SP A (601) SP Powerup [0x00] 4d495300 11a Errors like the following from the other array were reported: 11/15/2002 20:34:54 SP A (601) SP Powerup [0x00] 4d495300 11a 11/15/20