材料工程不锈钢.doc

Preparation and Electromagnetic Shielding Effectiveness of a new kind of electromagnetic shielding composite coatings Denggao Guan1,2,a, Yao Sun3, Guanli Xu3, Chuanmin Sun3,b, Huawei Li1,2 ,Wenjun Xu1,2 and Wenxin Zhou1,2 1College of Materials and Chemistry Chemical Engineering, Chengdu University of Technology, Chengdu, Sichuan, 610059, China 2Mineral Resources Chemistry Key Laboratory of Sichuan Higher Education Institutions, Chengdu, Sichuan, 610059, China 3College of Earth Sciences, Chengdu University of Technology, Chengdu, Sichuan, 610059, China agdg@cdut.edu.cn, bscm@cdut.edu.cn Keywords: electroless plating, electromagnetic shielding coating, glass fiber, electromagnetic environmental protection, electromagnetic shielding effectiveness Abstract. A new kind of the electromagnetic shielding composite coatings with high performance was prepared using the Ni-Cu-coated glass fibers and nickel powders as fillers and using epoxy resin as binder. The effects of the fibers on the conductivity and electromagnetic shielding effectiveness of the coatings were studied. The study results show as follows: 1) when the optimum ratio of the fillers to epoxy resin is 4：1, the coatings containing 6 wt% the Ni-Cu-coated glass fibers has best conductivity and electromagnetic shielding effectiveness; when the coating layer thickness is 300 μm, the shielding effectiveness of the coatings is up to 43.71-52.31 dB and increased an average of 13.94 dB compared with the nickel powders/ epoxy resin electromagnetic shielding coatings in the frequency range of 0.3-1000 MHz. This offers a new idea to raise the levels of the comprehensive utilization of mineral resources and the prevention of electromagnetic environmental pollution. Introduction As a kind of one of the hazards in the world, electromagnetic wave radiation pollution directly endangers economic construction, national defense safety and social production and life [1-2]. The pollution is becoming more and more harm to natura