ADS的仿真类型.docVIP

Not all simulation types are available in RFDE. ?Simulation Descriptions Simulator? Description? DC Fundamental to all simulations, it performs a topology check and an analysis of the DC operating point of a circuit. 所有仿真的基础，对电路拓朴进行检查，并分析其直流工作点。 AC Obtains small-signal transfer parameters, such as voltage gain, current gain, and linear noise voltage and currents. This simulator is useful in designing passive circuits and small-signal active circuits such as low-noise amplifiers (LNAs). 求取小信号传输参数，如电压电流增益、线性噪声电压电流。该仿真主要用于无源电路、以及小信号有源电路（如LNA）设计。 S-parameter Provides linear S-parameters, linear noise parameters, transimpedance (Zij), and transadmittance (Yij), by linearizing the circuit about the DC operating point and performing a linear small-signal analysis that treats the circuit as a multiport. Each port is turned on sequentially. S-parameters can be converted to Y- and Z-parameters. This simulator can be used to achieve many of the same design goals as the AC simulator. 通过在直流工作点附件线性化电路，并把电路做为一个多垛口电路进行小信号分析的方法，取得电路的线性S参数、线性噪声参数、跨电阻（Zij）、跨导（Yij）等。各个端口顺序打开。S参数可用于求取Y-参数和Z-参数。该仿真器和AC仿真器可取得许多共同的设计目标。 Harmonic Balance Uses nonlinear harmonic-balance techniques to find the steady-state solution in the frequency domain. This simulator is useful in designing RF amplifiers, mixers, and oscillators. A Krylov subspace technique is available to reduce memory requirements and increase the speed of solution. This option is useful in designing large RF integrated circuits or RF/IF subsystems, where a large number of devices or large numbers of harmonics and intermodulation products are involved. 在频域利用非线性HB方法求取稳定状态解，主要用于设计RF放大器、混频器、振荡器。HB可用Krylov子空间技术来减少内存要求并提高求解速度，这在大型RFIC以及RF/IF子系统设计中很有用，因为涉及到大量的器件或者大量的谐波以及交调产物。 Large-signal S-parameter (LSSP) A type of harmonic balance simulation, it performs large-signal S-parameter analyses to represent the nonlinear behavior of items such as power amplifiers. The accompanying P2D simulator available in ADS can be used to speed up subseq