smthome_贴装头的Z轴高度的调整步骤.pdfVIP

SI0070-M-E 5 November, 2001 Head Height Z Adjustment M1, For Magnet plate type 1. PREPARATIONS M005 Nozzle (Brand-new) Thickness gauge （0.1mm is recommended.） 2. PROCEDURES 2-1. Remove GUIDE,UPPER. (See 2 in attached figure.) 2-2. Input 0 in Z coordinate of Board (1) and save it. System →System Parameter →Parameter →Machine Origin →From Machine Origin →Board(1) →Z coordinate 2-3. Take all the origins. 2-4. Open Teaching window from Program Data. 2-5. Input GUIDE,SIDE(F) point where is nearest the board origin by using PCB camera. (See 1 in attached figure.) (The point is right edge if conveyor is left to right flow, and it is left end if conveyor is right to left flow. The center between second and third screw holes is appropriate point.) 2-6. Attach a M005 nozzle to Head 1. Move the head to the XY coordinates of 2-5. Move down the head by Z-axis Teaching until the nozzle tip comes closer to GUIDE,UPPER surface. 2-7. Put Thickness gauge between the nozzle and surface of GUIDE, UPPER. Move down the head slowly until the nozzle touches the thickness gauge slightly. 1 SI0070-M-E 5 November, 2001 2-8. Try to pull the thickness gauge. If you feel some resistance, it is appropriate height. (Do not forget the resistance touch.) 2-9. Note down the Z coordinate. 2-10. Measure Z height of Head 2 to Head 6. (In the same way as Head 1.) 2-11. Correct Z axis parameter by referring the noted Z coordinate. Add 1 mm of thickness gauge to standard offset +0.15mm. Then the reference value becomes +0.25. Examples of measured Z, Offset formula and Offset value are shown in the list below. (Offset value is data to input i