不同热喷涂技术制备镍基涂层的摩擦摩损性能.pdf

第 17 卷第 9 期 中国有色金属学报 2007 年 9 月 Vol.17 No.9 The Chinese Journal of Nonferrous Metals Sep. 2007 文章编号：1004-0609(2007)09-1506-05 不同热喷涂技术制备镍基涂层的摩擦磨损性能 1, 2 2 2 2 1, 2 伍超群 ，周克崧 ，刘 敏 ，邓畅光 ，邓春明 (1. 广东工业大学 材料能源学院，广州 510081 ； 2. 广州有色金属研究院 表面材料中心，广州 510650) 摘 要：利用超音速火焰喷涂技术和低压等离子喷涂技术，在铜基体上制备镍基涂层，研究涂层在室温下的摩擦 磨损特性，探讨涂层的磨损机理。结果表明，HVAF 制备的镍基涂层具有较好的耐磨性，主要原因是在涂层中存 在 Ni B 、M C 、M C 等硬质相，其磨损机理为磨粒磨损，而低压等离子喷涂技术制备的镍基涂层组织出现大量 3 23 6 7 3 的非晶态，硬度低，磨损机理为磨粒磨损和疲劳磨损的综合作用，并以疲劳磨损为主。 关键词：镍基涂层；超音速火焰喷涂；等离子喷涂；摩擦磨损 中图分类号：TG 174 文献标识码：A Wear properties of nickel-based coating sprayed by different thermal spraying technologies 1, 2 2 2 2 1, 2 WU Chao-qun , ZHOU Ke-song , LIU Min , DENG Chang-guang , DENG Chun-ming (1. College of Materials and Energy, Guangdong University of Technology, Guangzhou 510081, China; 2. Material Surface Center, Guangzhou Research Institute of Non-ferrous Metals, Guangzhou 510650, China) Abstract: The Nickel-based coating was prepared on copper substrate by high velocity air-fuel (HVAF) thermal spraying and low pressure plasma spraying (LPPS). The wear properties and wear mechanisms of coating were studied. The results show that in the nickel-based coating deposited by HVAF, the hardness is high and the wear resistance is good. The wear mechanism is abrasive wear. The wear mechanism of Ni-based coating deposited by LPPS is mainly fatigue wear. This is attributed to low hardness and amorphous phase existed. Key wo