31403032 EXTERNAL FUSION-BONDED EPOXY POWDER COATING.pdfVIP

TECHNICAL SPECIFICATION EXTERNAL FUSION-BONDED EPOXY POWDER COATING FOR LINE PIPE DEP 31.40.30.32-Gen. October 1995 DESIGN AND ENGINEERING PRACTICE This document is confidential. Neither the whole nor any part of this document may be disclosed to any third party without the prior written consent of Shell International Oil Products B.V. and Shell International Exploration and Production B.V., The Hague, The Netherlands. The copyright of this document is vested in these companies. All rights reserved. Neither the whole nor any part of this document may be reproduced, stored in any retrieval system or transmitted in any form or by any means electronic, mechanical, reprographic, recording or otherwise without the prior written consent of the copyright owners. DEP 31.40.30.32-Gen. October 1995 PREFACE DEPs Design and Engineering Practice publications reflect the views, at the time of publication, of: Shell Global Solutions International B.V. Shell GSI and Shell International Exploration and Production B.V. SIEP and Shell International Chemicals B.V. SIC and other Service Companies. They are based on the experience acquired during their involvement with the design, construction, operation and maintenance of processing units and facilities, and they are supplemented with the experience of Group Operating companies. Where appropriate they are based on, or reference is made to, international, regional, national and industry standards. The objective is to set the recommended standard for good design and engineering practice applied by Group companies operating an oil refinery, gas handling installation, chemical plant, oil and gas production facility, or any other such facility, and thereby to achieve maximum technical and economic benefit from standardization. The information set forth in these publications is provided to users for their consideration and decision to imp