《event car》.pdfVIP

15 Using the Event Builder Using the Event Builder In this chapter, you will learn the basics of creating multiple mini-maneuvers, establishing the appropriate application areas for those mini-maneuvers, and setting end conditions for each mini- maneuver. The chapter contains the following sections: • Creating an Event • Creating the Three Mini-Maneuvers • Defining the Mini-Maneuver Parameters • Running the New Analysis 16 Getting Started Using Adams/Car Creating an Event Before you can create an event, you must create a new file, as explained next. The instructions will point out differences between procedures in Adams/Car and Adams/Chassis, as needed. To display the Event Builder: • Do one of the following, depending on your MD Adams product. In Adams/Car: • Open the assembly MDI_DEMO_VEH. • From the Simulate menu, point to Full-Vehicle Analysis, and then select Event Builder. In Adams/Chassis: • In Build mode, from the toolbar, select the Load Example Model button . • Adams/Chassis displays the default example model. • From the Test mode bookshelf, select Full-Vehicle, select Handling Analysis, and then double-click Standard Driver Interface (SDI). • From the property editor, select the Edit button . Your MD Adams product displays the Event Builder, which is grayed out because you do not