Calibrating a J2 plasticity material model using a 2D inverse finite element procedure英文资料.pdfVIP

Available online at International Journal of Solids and Structures 45 (2008) 1244–1263 /locate/ijsolstr Calibrating a J2 plasticity material model using a 2D inverse finite element procedure Hasan Charkas a, Hayder Rasheed b,*, Yacoub Najjar b a Structural Fracture Mechanics Unit, AREVA NP Inc., Lynchburg, VA 24501, USA b Department of Civil Engineering, Kansas State University, Manhattan, KS 66506, USA Received 18 May 2007; received in revised form 13 July 2007 Available online 4 November 2007 Abstract Material models are the key ingredients to accurately capture the global mechanical response of structural systems. The use of finite element analysis has proven to be effective in simulating nonlinear engineering applications. However, the choice of the appropriate material model plays a big role in the value of the numerical predictions. Such models are not expected to exactly reproduce global experimental response in all cases. Alternatively, the measured global response at specific domain or surface points can be used to guide the nonlinear analysis to successively extract a representative material model. By selecting an initial set of stress–strain data points, the load–displacement response at the monitoring points is computed in a forward incremental analysis without iterations. This analysis retains the stresses at the integration points. The corresponding strains are not accurate since the computed displacements are not anticipated to match the mea- sured displacements at the monitoring points. Therefore, a co