《03-3-LG Arteor Home Automation F - How to expand automation system_CN》.ppt

下载文档 降价啦

1
0
约 26页
2015-10-19 发布于河南
举报
版权申诉
保障服务

《03-3-LG Arteor Home Automation F - How to expand automation system_CN》.ppt

1、本文档共26页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

* * * These limits can be exceeded using the SCS/SCS interface art. LGR003562 * MOD=1 PHYSICAL EXPANSION It can increase the total BUS length or exceed the absorption limit of 1.2A for every power supply. It is possible to connect up to 4 interfaces in series, which subdivide the system into five distinct sections. No address assigned also functional; I3I4 must be configured for physical expansion; e.g. I3I4=32, then IN subsystem1=11~31, the OUT subsystem2=32~99 (or another interface). * * MOD=1 PHYSICAL EXPANSION It can increase the total BUS length or exceed the absorption limit of 1.2A for every power supply. It is possible to connect up to 4 interfaces in series, which split up the system into five distinct sections. * * * * MOD=2 LOGICAL EXPANSION It can increase the number of devices of a system, which is 81 (max 9 rooms with 9 light points each). In this mode it is possible to connect up to 9 interfaces to the riser. There is the possibility of managing up to ten systems. * Different MOD must be configured for different functions e.g. AUTO/ALARM: MOD=4 CURRENCY ISOLATOR (MUSIC/AUTO)= - * * * * lThrough this SCS wide command it is possible in a very simple way to pilot from a situated command on the bus of an interface a situated actuator on the bus of another interface in direct way (without using the auxiliary commands as through); in fact the new command has a configurator dedicated to the address of the interface on whose bus is found the actuator that have been commanded, and transmits wide frame addressed to this interface I= 1 to 9: Address interface: I=0: the device is commanded on local BUS (level 3) I=CEN: is commanded a device on riser by a level 4 * * Through this SCS “extended command it is possible to pilot in a very simple way from a command located on the Bus of an interface an actuator placed on the Bus of another interface in direct way (without using the auxiliary commands as through); in fact the new command has a configur