《HID Kit Install for Volvo S40》.pdf

HID Install for Volvo S40 1 DDM HID Kit Install for Volvo S40 This is an install document for a High Intensity Discharge Kit for the Volvo S40. This is a fairly simple procedure and should take approximately 45 minutes to install. Kit Details DDM HID Kit including: 2 – Ballasts and Igniter assemblies 2 – HID Bulbs w/wire assemblies 2 – Ballast to Bulb connecting wires 2 – 3 M Double sided adhesive tape Tools Drill 1” Boring Drill Bit or similar File Electrical Tape Installation Instructions Caution – Be very careful working around HID lighting. These are very high voltage. Make sure the headlight is disconnected before working on the HID lighting system! 1. Find a good work area and remove the kit from the box. Make sure you have all the pieces. HID Install for Volvo S40 2 2. First you will need to remove the 6. Place the headlight on a soft surface to headlight assembly. avoid any scratches. 3. Remove the headlight holding pin. Set 7. Remove the back cover by releasing the the pin aside. metal retainers. 4. Pull the headlight slightly out to the 8. You will need to drill a hole in the back side and then forward. of the cover with the 1” drill bit. 5. Remove power connector by pushing 9. Run the wires from the light bulb down the tab and pull straight out. harness through the hole.