双粒度配比钨粉对W10Cu 复合材料致密化.pdfVIP

42 5 () Vol.42 No.5 2011 5 Journal of Central South University (Science and Technology) May 2011 W-10Cu ( 410083) 0.52.57.5 24 µm 3׃15׃110׃1 15׃1 2 3׃1W-10Cu 10׃1 15׃1 W-10Cu 98.9% 23.8 S/m W-Cu TG146.2 A 1672−7207(2011)05−1238−05 Influences of proportion of dual particle size on densification, microstructure and properties of W-10Cu composite material FAN Jing-lian, ZHANG Xiao, YOU Feng, TIAN Jia-min (State Key Laboratory of Powder Metallurgy, Central South University, Changsha 410083, China) Abstract: Four kinds of tungsten powders with various particle sizes of 0.5, 2.5, 7.5 and 24 µm were used to compose four sorts of mixed tungsten powders, which have two particle sizes and their ratios are 3:1, 5:1, 10:1 and 15:1. In all the cases, the mass ratio of coarse particle component to fine particle one is 3:1. These mixed tungsten powders were then pressed into tungsten skeleton, followed by copper infiltration to fabricate W-10Cu composite. The effects of the particle size ratio on the properties of sintering density, hardness, conductivity and microstructure of the composite were investigated. The results show that the sintering density, hardness and conductivity of the W-10Cu composite increase when the particle size ratio increases from 3:1 to 15:1. In the cases of the particle size ratios of 10:1 and 15:1, the relative density and the conductivity of the composite exceed 98.9% and 23.8 S/m, respectively, accompanied by the bonding between tungsten and tungsten particles as well as the formation of obvious sintering necks. Key words: W-Cu material; infiltration; particle s