基于Adams与AMESim的高线打包头联合仿真_郭晓宁.pdfVIP

2013 年 10 月 机械科学与技术 October 2013 32 10 Mechanical Science and Technology for Aerospace Engineering Vol． 32 No． 10 第 卷 第 期 基于Adams 和AMESim 的高线打包头联合仿真 ， 郭晓宁 邓 婷 ( ， 350 108) 福州大学机械工程及自动化学院 福州 郭晓宁 : Adams AMESim ， AMESim 摘 要 采用 和 分别建立打包头的机械系统和液压控制系统模型 并在 ， 、 中将两子系统模型根据参数关联有机集成为机电液一体化模型 最终实现打包头机械 液压和控制 。 : ， 系统的联合仿真 联合仿真结果表明 打包头不同阶段的运动与设定目标一致 从而验证了打包头 机械系统模型以及液压回路和参数设置的正确性。 : ;Adams ;AMESim ; 关 键 词 打包头 联合仿真 中图分类号:TP391． 9 文献标识码:A 文章编号:1003-8728 (20 13)10-1542-04 Co-simultion of High Wire Baler-header Based on Adams and AMESim Guo Xiaoning ，Deng Ting (School of Mechanical Engineering and Automation ，Fuzhou University ，Fuzhou 350108) Abstract :To make the movements of high wire baler-header meet the operating requirements ，the mechanical mod- el and hydraulic system model of baler-header were built with Adams and AMESim in this paper ，an electromechan- ical liquid integration model was integrated with two subsystem models according to the associated parameters in AMESim ，and the co-simulation of the mechanical system ，hydraulic system and control system was achieved． The co-simulation results showed that the movement of baler-header at different stages is consistent with the setting one ， and the correctness of the mechanical model ，hydraulic circuit and parameters were also verified． The present study provid a valid theoretic basis for the parameter design and m