hollowmetaldoorsandframes-MetroTransit.docVIP

Copyright 2011 by The American Institute of Architects (AIA) Exclusively published and distributed by Architectural Computer Services, Inc. (ARCOM) for the AIA SECTION 08 11 13 HOLLOW METAL DOORS AND FRAMES GENERAL RELATED DOCUMENTS Retain or delete this article in all Sections of Project Manual. Drawings and general provisions of the Contract, including General and Supplementary Conditions and Division?01 Specification Sections, apply to this Section. SUMMARY Section includes hollow-metal work. Related Sections: Section 01 23 00 - Alternates Section 08 71 00 - Door Hardware Section 08 81 00 - Glazing Retain subparagraphs below to cross-reference requirements Contractor might expect to find in this Section but are specified in other Sections. DEFINITIONS Retain Minimum Thickness Paragraph below to indicate that metal thicknesses specified are base-metal measurements and do not include metallic coatings or finishes. Thicknesses indicated in this Section are according to SDI?A250.8 and NAAMM-HMMA?803, both of which use the same values. Minimum Thickness: Minimum thickness of base metal without coatings according to NAAMM-HMMA?803 or SDI?A250.8. COORDINATION Coordinate anchorage installation for hollow-metal frames. Furnish setting drawings, templates, and directions for installing anchorages, including sleeves, concrete inserts, anchor bolts, and items with integral anchors. Deliver such items to Project site in time for installation. PREINSTALLATION MEETINGS Retain Preinstallation Conference Paragraph below if Work of this Section is extensive or complex enough to justify a conference. Preinstallation Conference: Conduct conference at Project site. If needed, insert list of conference participants not mentioned in Section?013100 Project Management and Coordination. ACTION SUBMITTALS Product Data: For each type of product. Include construction details, material descriptions, core descriptions, fire-resistance ratings and finishes. Retain Shop Drawings Paragraph below