Productionofaworkpiecestop-Siemens.PDFVIP

Production of a workpiece stop workpiece stop Every workshop should have one, a workpiece stop. Always went several identical parts must be machined, and the same machining steps must be repeated The workpiece stop helps do this. For example, when drilling, it always ensures the same clamping length; the same is true when cutting or other machining steps. Using the adjustable joint of the workpiece stop, the optimum position of the workpiece stop needle can be set and fixed. An M8 cylinder screw allows the stop to be mounted. All of the individual parts of the workpiece are machined from commercially available materials. All information, tool data and machining plans required for the reproduction are summarized in the following sections. 2/ Contents 1. Safety note 15. Tools to drill the needle holder 2 2. Preliminary remark 16. Machining step, milling the outer foot 3. Drawing list and head contours 4. –Workpiece blank 17. Milling the outer foot and head 5. Milling machine and machining plan contours JobShop 18. Machining the clamping jaws 6. Tools 19. Milling the inside of the side part 7. Tools to mill the clamping jaws 20. Milling the outside of the side part 8. Tools to mill the inside of the side 21. Milling the bolt with through hole parts 22. Milling the bolt with thread 9.