basicelectricale.docVIP

BASIC ELECTRICAL ELECTRONIC ENGINEERING JAN. 2002 N.B.: (1) Question Nos. 1 and 6 are compulsory. (2) Attempt total three questions from each section. (3) Answer to the two sections must be written in separate answer books. (4) Figures to the right indicate full marks. (5) Make suitable assumptions where necessary, stating the same. Section I 1. (a) Find RAB in following circuit. (3) (b) Define phase, from factor, crest factor. (3) (c) Derive e.m.f. equation of transformer. (3) (d) A 220 V d.c. shunt machine has an armature resistance of 0.5 ohm. If the full load armature current is 20 Amp, find the induced e.m.f. when the machine acts as (i) generator (ii) motor. (3) (e) Explain 2 transistor analogy of SCR. (3) (f) State advantage of electrical transducers. (3) 2.(a) A coil has 25 ohm resistance at 40°c and 45 ohm resistance at 100°C. Find its resistance and resistance temperature coefficient at 0°C. (4) (b) A 40 KVA, 3300/240 V, 50 Hz, 1 phase transformer has 660 turns on the primary. Determine: (4) (i) The number of turns on the secondary (ii) the maximum value of flux in the core (iii) the approximate value of primary and secondary full load currents Internal drops in the windings are to be ignored. (c) Show that current through pure inductance lags behind the applied sinusoidal voltage by 90°. Also show that pure inductance does not consume any power. Draw voltage current and power waveforms. (8) 3. (a) A current of 5A flows through a non- inductive resistance in series with a choking coil (coil is impure, it has some resistance) when supplied at 250 V, 50 Hz. If the voltage across the resistance is 125v and across the coil 200 V, calculate. (8) (i) Impedance, reactance and resistance of the coil (ii) The power absorbed by the coil (iii) The total power. Draw the vector diagram (Not to scale) . (b) Explain double field revolving theory. How 1 phase induction motor is made self starting? (8) 4. (a) Explain charging action of lead acid battery. (8) (b) St