IO_Spec-update.doc-Nuuo.docVIP

SCB-C08 USB to RS232/422/485 Converter Specifications USB Interface Compliant with USB V1.0 and V2.0 RS-232 signal 5 full-duplex (TXD, RXD, CTS, RTS, GND). RS-422 signal: 4 half-duplex wires (TX+, RX+, TX-, RX- ). RS-485 signal: 2 half-duplex wires (D+, D-). Cable Type USB type A to type B. Transmission distance RS485 Up to 4000ft (1200M). Signal LED Power on, TX, RX. Direct power from USB port Support Power consumption: 1.2W Dimension 151 x 75 x 26 mm Introduction SCB-C08 is an independent control device for managing signals from RS-232, RS-422 and RS-485. Devices such as I/O relay device or speed dome can be easily control by SCB-C08. 1. Power Connection (USB Internal Bus) Direct power input from USB bus port, current 100mA/+5V, no external power necessary 2. RS-232 wiring connection The RS-232 supports 5 channels plus Signal Ground and is configured as DTE like a computer. Signals are single ended and referred to Ground. To use handshaking or flow control user must set Host PC’s RTS/CTS during configuration. Refer to the pin assignment for connection as below. 3. RS-485 Wiring connection The RS-485 mode supports the Transmit and Receive channels using 2-wire half-duplex operation. Refer to the pin assignment for connection as below. 4. Block Diagram 5. Application Note SCB-C24 16-ch Digital Output Insolated RS485 Module Specifications Output Channel 16 digital output channels Communication Interface RS-485 differential 2 half / duplex wires Communication Speed Baud rate from 1.2 Kbps to 115.2 Kbps Transmission distance RS485 Up to 4000ft (1200M). Signal LED Power on, all output channels Dual watchdog Reset circuit module / Host operating status Power supply Screw terminal, or external DC adapter Power consumption: 1.5W Dimension 151 x 75 x 26 mm Introduction SCB-C26 provides 16 optical isolated digital output channels that allow you to output open collector signal to driven your devices on RS485 network. All channel features