Philips Xenium Service Manual Level1.docVIP

SERVICE MANUAL Repair for Cellular Telephone XENIUM DUAL BAND LEVEL 1 Service Manual Last updates: DATE MODIFICATION PAGE 19/06/2000 CREATION Revision 2 : 26/07/2000 - Modification of components list Page 23 CONTENTS 1.0 PURPOSE 4 2.0 SCOPE 4 3.0 REFERENCE 4 4.0 Glossary/Acronym List 4 5.0 Test Equipment and Tools 4 6.0 Test and inspection Plan 5 6.1 User Interface Test 5 6.2 RF Test 5 7.0 Before Starting 6 7.1 Description of the transceiver 6 7.2 Description of the display 7 7.3 Using The Carousel 8 7.4 Inserting the MICRO-SIM card 9 7.5 Inserting on the battery 9 7.6 Removing the battery 10 7.7 Charging the battery 10 8.0 TEST PROCEDURES 11 8.1 Initial Functional check for TCD989/J XENIUM 11 8.2 RF TEST 15 8.3 Charging IGN (Ignition) – Battery 18 9.0 assembly / dismantlement procedures 19 9.1 Dismantlement 19 9.2 Assembly 19 10.0 Defaults Settings 20 10.1 Reset customer parameters. 20 10.2 Use of the GSM string *#RSAV*# or *#7728*#. 20 11.0 SOLUTIONS IN CASE OF PROBLEMS DURING THE TESTS 21 11.1 The phone does not switch on. 21 11.2 Charge does not start or no detection of the charger. 21 11.3 The display shows “No SIM card. Please insert your SIM card.” or “SIM FAILURE” 21 11.4 Display problems 22 11.5 Buzzer problems 22 11.6 No sound in Loudspeaker 22 11.7 Communication problems 22 11.8 Defective antenna 22 11.9 Keyboard problems 22 11.10 Problems to send SMS messages 22 12.0 recommended PART LIST- tcd 989 XENIUM DB 23 12.1 Common parts – out of warranty 23  PURPOSE This document establishes the functional test and inspection procedures for the first level service repair of the XENIUM DB transceiver SCOPE The test plan is applicable to all levels of service repair of the XENIUM DB transceiver REFERENCE Glossary/Acronym List Window or Bezzel Protective plastic over the LCD display SW Software PN Hardware Configuration of the Mobile CN Matrix for Types of SW used on the different hardware HW Hardware ASC Authorized Service