圆钢管销铰连接中端板的受力性能和强度计算.PDFVIP

圆钢管销铰连接中端板的受力性能和强度计算 1 1 2 孟宪德 ，陈以一 ，杜纯领 (1.同济大学 土木工程学院，上海 200092; 2.奥雅纳工程咨询 （上海）有限公司，上海 200031) 要：本文对圆钢管销铰连接中端板的力学性能进行了研究。建立了端板的简化力学模型，对端板的受力机理进行了探讨。建立了 便于使用的端板承载力计算公式，根据建立的100 个有限单元参数模型的线弹性计算结果，给出了计算公式中各系数的计算表格， 给出了表格的使用方法和算例。最后对计算表格的有效性进行了评价，并得出一些对此类节点设计有参考价值的结论。 关键词：钢管节点；支座节点；端板；承载力 中图分类号： 文献标识码：A Ultimate Capacity of Unstiffened Cover-Slab of Tubular Structure Using In the Supporting Joint 1 1 2 Meng Xiande , Chen Yiyi , Du Chunling (1.College of Civil Engineering, Tongj i University, Shanghai 200092, China ；2.Arup International Consultants (Shanghai) Co. Ltd, Shanghai 200031, China) Abstract: Ultimate capacity of unstiffened cover-slab of tubular structure using in the supporting j oint is researched in the paper. The mechanical principle of the unstiffened cover-slab is discussed, and the mechanical models are established. Based on the model, the formulas of bearing capacity are recommended. According to the results of finite element analysis of 100 models which vary with the geometrical parameters, two handy tables of the factors in the bearing capacity formulas are established. And the applying method of the tables is given by an example. Finally the evaluation on validity of the tables is given ，and some valuable conclusions are drawn from the tables. Keywords: tubular j oint ；supporting j oint ；cover-slab ；ultimate capacity. 如果将耳板对端板的反力简化为均布荷载，钢 1 简介 管对端板的约束简化为简支支座，端板的受力状态 在管结构中，经常采用图1 所示端部节点：钢 则可简化为力学模型一，如图2 所示。实际结构中， 管端部封焊一块圆形端板，端板外侧立焊一块耳 端板直径大于钢管直径 （图1），分析中可视端板 板，耳板