吹风比对平板气膜冷却特性影响的实验研究.pdfVIP

25 卷 18 期 中 国 电 机 工 程 学 报 Vol.25 No.18 Sep. 2005 2005 年9 月 Proceedings of the CSEE 2005 Chin.Soc.for Elec.Eng. 文章编号：0258-8013 (2005) 18-0091-06 中图分类号：TM311 文献标识码：A 学科分类号：47030 吹风比对燃汽轮机平板气膜冷却 特性影响的实验研究 韩振兴, 刘 石, 刘建军, 周嗣京, 刘 杰 ( 中国科学院工程热物理研究所，北京市 海淀区100080) EXPERIMENTAL RESEARCH ON FILM COOLING CHARACTERISTICS AT DIFFERENT BLOWING RATIOS HAN Zhen-xing, LIU Shi, LIU Jianjun, ZHOU Si-jing, LIU Jie (Institute of Engineering Thermophysics, Chinese Academy of Science, Haidian District, Beijing 100080,China) ABSTRCT: This paper reports the current studies on the film 条件下的换热系数分布和其对应的冷却效率分布基本相同。 cooling characteristics of single-row holes on flat plate at 关键词：热能动力工程；燃汽轮机；气膜冷却；热敏液晶图 different blowing ratios, and analyzes the distributions of adiabatic film cooling effectiveness and heat transfer coefficient 像技术；吹风比 downstream the film holes. The research is conducted at three 1 引言 blowing ratios, 0.5, 1.0 and 1.5, respectively. The Reynolds Number based on the film hole diameter ReD is 13600. The 目前燃气轮机在航空、舰船和电站等领域已得 density ratio of the inj ection flow and the mainstream is 到了广泛应用。提高燃气轮机运行性能的经济性日 maintained at 0.88 by controlling the temperature of the 益引起关注。提高燃气透平入口温度是提高燃气轮 inj ection flow. The liquid crystal thermography is used to