基于炉内三维燃烧检测的蒸发系统动态建模与分析－、模型建立.pdfVIP

26 卷 9 期 中 国 电 机 工 程 学 报 Vol.26 No.9 May 2006 2006 年5 月 Proceedings of the CSEE 2006 Chin.Soc.for Elec.Eng. 文章编号：0258-8013 (2006) 09-0020-06 中图分类号：TK 12; TK22 文献标识码：A 学科分类号：47010 基于炉内三维燃烧检测的蒸发系统分布参数建模 初云涛, 周怀春 (华中科技大学煤燃烧国家重点实验室，湖北省 武汉市 430074) Distributed-parameter Modeling of Evaporation System Based on Three-dimensional Combustion Monitoring in Furnace CHU Yun-tao, ZHOU Huai-chun (State Key Laboratory of Coal Combustion，Huazhong University of Science and Technology, Wuhan 430074, Hubei Province, China) ABSTRACT: The non-uniformly distribution of two- 关键词：热能动力工程；燃烧检测；蒸发系统；分布参数； dimensional radiation flux on the surfaces of water-cooled tubes 动态建模 in a furnace is obtained through the three-dimensional 0 引言 temperature distribution and the furnace radiation energy signals which are got by a real-time visualization monitoring 炉膛火焰在空间 的分布是蒸发系统的边界 system for the three-dimensional combustion. By the radiation 条件，受热面的受热状况对锅炉蒸发系统的动态特 flux distribution taken as the boundary condition, a dynamic, parameter-distribution model for the evaporation system is 性有显而易见的影响。在现有的蒸发系统建模的研 established, which can give the dynamic distributions of the 究中，以整个水冷壁或者蒸发系统为集总参数对象 wall heat flux, wall temperature, mass fraction of steam and 进行建模时，只考虑热流总量不考虑热流的分布特 mass velocity outside/inside the evaporation system, and the [1-2]