西门子WinCC和HMI人机界面.docVIP

WinCC與HMI人機介面bject－Picture，新增一圖片在Component view視窗下，點選ES－WinCC Application－OSOK返回 滑鼠左鍵雙擊OS Project Editor 進入OS Project Editor畫面後，選取上方Layout標籤，並選取螢幕解析度與數量 按OK確認 返回Component視窗，點選ES－WinCC Application－OSData：勾選Tags and messages與Picture Tree Scope：點選Entire OS，並勾選With memory reset：OP_D、OP_A、DIG_MON、MEAS_MONOP_D 在該Block上按滑鼠右鍵－Object Properties 進入後可見Create block icon有打勾，但底下欄位空白，表示其採用內建Faceplate 程式編輯完成後，執行OS Compile OS Compile完成後打開該程式人機介面圖檔 圖片開啟後可見其OP_D內建Faceplate 如須依使用者須求更改內建Faceplate，則先開啟WinCC Application 點選左方視窗內的Graphics Designer，再雙擊右方視窗內的@@PCS7Typicals.PDL 進入後選取內建OP_D，按滑鼠右鍵－Duplicate，複製一組OP_D 將複製所得OP_D標籤更改為OP_D/2，並移至空白處，以方便辨識 在物件上按滑鼠右鍵－Properties 點選左方視窗內的Customized object 再將右方視窗內的Object Name更改為@OP_D2 點選左方視窗內的General，滑鼠左鍵雙擊右方視窗內的type 將Output Value修改為@OP_D/2，按OK確定修改t，依須求更改字型與字體位置 修改完成如圖所示 點選紅色RESET按鈕，再點選File－Exportt－Editct－Finish editingFile－Save As2 (因該物件為@OP_D/2)，按OK 1. Click right key of mouse 2. Select Insert New Object 3. Select Picture Key in the name of picture Click right key of mouse Select Open Object Select Computer Click right key of mouse Select Properties Key in the Computer Name same as your computer Click OK Double click left key of mouse 1. Select Layout 2. Select screen resolution 3. Select monitor configuration Click OK 1. Select ES 2. Click right key of mouse 3. Select Compile Click Next 1. Select Station 2. Click Next 1. Click Connection 2. Click Next Select S7 Connection (when adopt OS+CP1613) 2. Click OK 1. Select Tags and messages 2. Select Picture Tree 3. Select Entire OS 4. Select With memory reset 5. Select 1 second 6. Click Next Click Compile This is a OP_D block 1. Click right key of mouse 2. Select Object Properties Here is empty So use default faceplate Click OK Double click the picture Default OP_D faceplate 1. Click right key of mouse 2. Select Open Object 1. Select Graphics Designer 2. Select @@PCS7Typicals.PDL Click right key of mouse and select Duplicate Rename to OP_D/2 Click right key of mouse Select Properties Select Customized objec