废水处理及水纯化要点.ppt

* Waster Water Treatment Instruction 1.The powder coating line must try best to reduce the wastewater discharging and control the quantity every time. 喷粉生产应采取措施尽可能地减少喷粉废水的排放，控制每次废水排放量 2. The discharged wastewater must be collected in a stated pool and no random putting permitted. 排放的废水必须收集于规定的收集池，不得任意排放 3. A necessary Waste Water Record is required when movement the waste water. The monitor dept. should affirm and approved. 每次处理废水必须填写《废水处理记录》，各监督部门确认和批准 Powder coating Waste water Operational Instruction Powder coating Waste water Operational Instruction (1) Powder coating Waste water Flow Chart 1. Confect the medicament 药剂的配置（一） (1) Concentration of Ca(OH)2 5%~10% 氢氧化钙的浓度 (2) Concentration of PAC 5%~10% 聚氯化铝的浓度 (3) Concentration of PAM 0.5‰~1‰ 聚丙烯酰胺的浓度 (4) Concentration of Ca(CL)2 5%~10% Ca(CL)2的浓度 (5) Concentration of H2SO4 5%~10% 硫酸的浓度 Powder coating Waste water Operational Instruction Powder coating Waste water Operational Instruction 2. Confect the medicament 药剂的配置（二） （1）用桶子将药剂溶解方能加到相应的加药桶中。 （2）每个药桶为500KG，计算其加药量。 （3）所有加药桶中必需开起流化汽，Ca(OH)2加药桶必需开起搅动泵。 （4）每天必须用清水清洗其管道及泵 Powder coating Waste Water Operational Instruction 一 .Degreased Waste Water Treatment System 脱脂废液预处理系统 Powder coating Waste Water Operational Instruction 1. Open the valve of the degreased water, and then open the tap water, when the container is full, start up the pump, pump the waste water up to the pre-treatment groove. 打开脱脂废液泵进出口阀门，打开自来水引水阀门，待水引满后，启动脱脂废液泵，把废液提升到预处理槽至高液位自动停止 2. Open the compress gas to mix the medicament. Add the CaCl2, Ca(OH)2 and PAC and mix for 3 to 5 min(PH=10~10.5) ,then add the PAC ,sampling and observe, if have obvious flocculate, it will be ok. 打开压缩空气搅拌，分别加入氯化钙，氢氧化钙和聚氯化铝，并搅拌3~5分钟，保持PH=10~10.5.然后加入聚丙烯酰胺，取样观察，有明显的絮凝物即可 Powder coating Waste Water Operational Instruction Powd