径向流吸附器流体流动特性及其结构参数优化.pdfVIP

第 65 卷 第 9 期 化 工 学 报 Vol.65 No.9 2014 年 9 月 CIESC Journal September 2014 径向流吸附器流体流动特性及其结构参数优化 陈瑶，张学军，陆军亮，邱利民，张小斌，孙大明，甘智华 （浙江大学制冷与低温研究所，浙江杭州 310027 ） 摘要：径向流吸附器通常存在流体沿轴向床层分布不均匀，从而导致吸附剂利用率下降和空分系统运行安全性问 题。通过对表征 Z 型径向流吸附器流动特性的微分控制方程中包含的结构参数进行量纲 1 化，系统地研究了各结 构参数对吸附器内流体分布的影响。同时针对实验室已有的一台 Z 型径向流吸附器，采用理论求解和实验数据对 照的方法验证了模型的可靠性。结果表明，减小吸附床层轴向高度和吸附剂颗粒直径能显著提高 Z 型径向流吸附 器内流体分布的均匀性；当空气的运动黏度和其他结构参数不变时，吸附器的空气处理量在一定范围内变化对吸 附床层内流体的均匀性影响不大。 关键词：径向流；吸附；流动特性；结构参数；优化；模型 DOI ：10.3969/j.issn.0438-1157.2014.09.012 中图分类号：TQ 116 文献标志码：A 文章编号：0438—1157 （2014 ）09—3395—08 Flow characteristics of radial flow adsorber and its structure parameters optimization CHEN Yao, ZHANG Xuejun, LU Junliang, QIU Limin, ZHANG Xiaobin, SUN Daming, GAN Zhihua （Institute of Refrigeration and Cryogenics, Zhejiang University, Hangzhou 310027, Zhejiang, China ） Abstract: Non-uniform flow distribution along the axial direction usually exists in a Z-flow type radial flow adsorber which will decrease the utilization of adsorbents and even result in operating safety problems in cryogenic air separation. The structure parameters in a differential equation which determined the flow characteristics of Z-flow type radial flow adsorber were dimensionlessly processed, and the effects of structure parameters on flow distribution in the adsorber were investigated. The theoretical result of the flow distribution in an experimental radial flow adsorber was in agreement with the experimental data. Reducing the axial height of adsorption bed and the diameter of adsorbent particle could