SeatPlasticPartsDesignTraining资料.ppt

If the bezel compresses the foam and trim cover, the amount of interference is usually equal with the thickness of the plastic part installed. Alsoo, consider a line to line interface of the plastic part with the foam pad. These considerations also depend upon the styling and customers requirements.-A 15 mm minimum of trim is required underneath the plastic bezel.-The foam must be designed to take the shape and accommodate the plastic bezel, but a minimum of 20 mm thickness of the foam is required between the bezel and the structure. Plastic parts design training——座椅塑料件设计 inslalled directly against the structure, at nominal we must have the carpet covered with the plastic part for a dimension of 10 mm minimum (12 mm at corners). The maximum dimension of the carpet covered by a plastic part is based on the size of the opening and on the testing required by the customer (load floor, ingress/egress, etc.). 地毯盖板 Plastic parts design training——座椅塑料件设计 Plastic parts design training——座椅塑料件设计 Plastic Part Design Guidelines These guidelines are only for reference ，Please don’t spread abroad. Plastic parts design training——座椅塑料件设计 Plastic parts design training——座椅塑料件设计 一、旁侧板设计手册 旁侧板外观面尽量符合STO，符合一定的审美取向; 一般来说，旁侧板为非结构件 Plastic parts design training——座椅塑料件设计 材料：一般选用PP 或者PP+T10 如果有特殊要求可选用ABS或者TPO 外观面的设计需要考虑： 1.壁厚，推荐壁厚2.5-3.0mm; 2.外观面尽量符合STO，边界轮廓避免与运动件存在干涉； 3.设计时考虑拔模角度，如果没有客户输入，推荐拔模角度不小于5度； 4.分型线避免设计在A面上 5.外观面上圆角要求尽量做大，最小圆角为0.5mm Plastic parts design training——座椅塑料件设计 Plastic parts design training——座椅塑料件设计 推荐：旁侧板与STO面的最小过盈为6mm Plastic parts design training——座椅塑料件设计 — stepped side face foam:the same minimum value（6mm） *Note on trim durability: During jounce and squirm cycling, trim doesnt actually rub against the side shield as much (or as linearly) as one might think. Rather, the rubbing action is smaller and more semi-circular in nature, with the fabric working around the shields edge locally. Plastic parts design training——座椅塑料件设计 Draft angles and shut-o